Chip breaking phenomenon during cutting steel and polymer materials
Journal Title: Production Engineering Archives - Year 2017, Vol 0, Issue
Abstract
Research in 60s and 70s started to deal with the shape of the chip characterization. It was possible then to do a limited study by means of measuring tool park. During such a study, different models for chip formation became familiar, such as the Time or Merchant model. The aim of article is to gain insight into some accompanying phenomena, occurring while cutting of different materials and with various tools. During an experimental design, the possible effects of different variables on each other and individually were considered. Two work-pieces (C45, POM) with two inserts (with two different edge design) were tested while changing of cutting speed and feed. During measurements cutting forces at 5000 Hz signal reception were tested or the evolution of cutting temperature at different experimental settings was evaluated. The chip characteristics are measured by a high speed camera. The camera is connected with PC for recording and controlling the experimental procedure in real-time. The frequency of High Speed Camera was similar than the frequency of the cutting force measuring system. This similarity is provided with the system set-up synchronization.
Authors and Affiliations
J. Liska
Keywords
Related Articles
- EP ID EP261100
- DOI -
- Views 83
- Downloads 0
Using Overall Equipment Effectiveness indicator to measure the level of planned production time usage of sewing machine
The chapter presents the results of utilization of the OEE indicator to measure the level of operating time usage of sewing machine production of air bags. The idea of an OEE indictor, which is a key metrics in Total Pro...
Use of statistical acceptance of products in the automotive industry
The article presents the results of studies on the implementation of statistical acceptance of products with the example of a styrene-rubber plastic connector, while considering particular stages of production. The chara...
Determinants of the quality of brazed joints of nickel-based superalloys
Aluminium is one of raw materials that can be practically continuously recycled. Thanks to the proper sorting of aluminium scrap it is possible to produce precisely the same products that it was made before Selective was...
Context of production engineering in management model of Value Stream Flow according to manufacturing indus-try
The popularity of visual management in the lean concept is caused by the possibility to apply it in solving different kind of issues related to reduce waste or process planning. The adaptations of VSM is focused on strea...
Using the Shewhart control charts by process control
This article deals with the statistics pursing the process capability of turning in screws production in RIBE Slovakia, k.s. In technical prac-tice, an important group of statistic methods is formed by analyzing qualific...