Comparative evaluation of tableting compression behaviors by methods of internal and external lubricant addition: Inhibition of enzymatic activity of trypsin preparation by using external lubricant addition during the tableting compression process
Journal Title: The AAPS Journal - Year 2001, Vol 3, Issue 3
Abstract
This study evaluated tableting compression by using internal and external lubricant addition. The effect of lubricant addition on the enzymatic activity of trypsin, which was used as a model drug during the tableting compression process, was also investigated. The powder mixture (2% crystalline trypsin, 58% crystalline lactose, and 40% microcrystalline cellulose) was kneaded with 5% hydroxypropyl cellulose aqueous solution and then granulated using an extruding granulator equipped with a 0.5-mm mesh screen at 20 rpm. After drying, the sample granules were passed through a 10-mesh screen (1680 μm). A 200-mg sample was compressed by using 8-mm punches and dies at 49, 98, 196, or 388 MPa (Mega Pascal) at a speed of 25 mm/min. The external lubricant compression was performed using granules without lubricant in the punches and dies. The granules were already dry coated by the lubricant. In contrast, the internal lubricant compression was performed using sample granules (without dry coating) containing 0.5% lubricant. At 98 MPa, for example, the compression level using the external lubricant addition method was about 13% higher than that for internal addition. The significantly higher compressing energy was also observed at other MPas. By comparison, the friction energy for the external addition method calculated based on upper and lower compression forces was only slightly larger. The hardness of tablets prepared using the internal addition method was 34% to 48% lower than that for the external addition method. The total pore volume of the tablet prepared using the external addition method was significantly higher. The maximum ejection pressure using the no-addition method (ie, the tablet was prepared using neither dry-coated granules nor added lubricant) was significantly higher than that of other addition methods. The order was as follows: no addition, external addition, and then internal addition. The ejection energy (EE) for internal addition was the lowest; for no addition, EE was the highest. In the dissolution test, the tablets obtained using external addition immediately disintegrated and showed faster drug release than those prepared using internal addition. This result occurred because the water penetration rate of the tablet using the external addition was much higher. The trypsin activity in tablets prepared using the external addition method was significantly higher than that produced using the internal addition method at the same pressure. All these results suggest that the external addition method might produce a fast-dissolution tablet. Because the drug will be compressed using low pressure only, an unstable bulk drug may be tableted without losing potency.
Authors and Affiliations
Makoto Otsuka, Mitsuyo Sato, Yoshihisa Matsuda
Permeability Comparison between Hepatocyte and Low Efflux MDCKII Cell Monolayer
Determination of passive permeability is not only important for predicting oral absorption and brain penetration, but also for accurately predicting hepatic clearance. High throughput (HT) measurement of passive permeabi...
Wet granulation fine particle ethylcellulose tablets: Effect of production variables and mathematical modeling of drug release
In the present study, the applicability of fine particle ethylcellulose (FPEC) to produce matrix tablets by a wet granulation technique was evaluated. The effect of various formulation and process variables, such as FPEC...
International Guidelines for Bioequivalence of Systemically Available Orally Administered Generic Drug Products: A Survey of Similarities and Differences
The objective of this article is to discuss the similarities and differences among bioequivalence approaches used by international regulatory authorities when reviewing applications for marketing new generic drug product...
Pancreatic Cancer: Pathobiology, Treatment Options, and Drug Delivery
Pancreatic cancer is the fourth leading cause of cancer-related deaths in the USA. The high mortality rate is partly due to lack of effective treatments. This review summarizes the pathobiology and current treatment opti...
Lipidomics Revealed Idiopathic Pulmonary Fibrosis-Induced Hepatic Lipid Disorders Corrected with Treatment of Baicalin in a Murine Model
The online version of this article (doi:10.1208/s12248-014-9714-4) contains supplementary material, which is available to authorized users.