Comparative Study of SAE 1141 Carbon Steel, T651-7075 Aluminum Alloy & 4340 Billet Steel Material for Connecting Rod using ANSYS 16
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 1
Abstract
A connecting rod is a link which derives the rotary motion from the reciprocating motion of piston. Many materials are used for connecting rod. Every material has its own advantages and disadvantages, and are used depending upon the engine requirement, purpose of the engine and other factors that matter. In this paper, a connecting rod with three different materials viz. SAE 1141 Carbon Steel, T651-7075 Aluminum Alloy & 4340 Billet Steel, have been designed using CATIA V5 R20 and analyzed using ANSYS 16. Deformation, equivalent stress and equivalent strain of the connecting rod for all the three materials were compared to the same loads.
Authors and Affiliations
GURPREET SINGH MATHAROU, SUNNY BHATIA, MOHD. TANZEEL, PIYUSH VIRMANI, SANGRAM BISWAS
Keywords
Related Articles
- EP ID EP280232
- DOI 10.24247/ijmperdfeb201875
- Views 81
- Downloads 0
Performance Evaluation of VCR CI Engine Using C-D Intake Manifold With Internal Grooving
Compression ratio (CR) is a design parameter that influences efficiency, characteristics as well as emissions from the engine. Varying of Compression Ratio is done to increase fuel efficiency under varying loads. The exp...
Design and Implementation of Zeta Micro-Inverter for Solar PV Application
Microinverter is attached on each photovoltaic (PV) panel, i.e., Microinverter is improving due to increased energy harvest from the solar panel. This paper proposes a design and implementation of a single stage ZETA Mic...
Heat Transfer Characteristics for A Fin Exposed to Fully Wet Air
A numerical method for two types of longitudinal tapered fins exposed to fully wet air conditions have been studied using grid generation methods. The study included the effect of relative humidity on the temperature dis...
Analysis and Optimization of Glass Fiber with Epoxy Resin Composite Leaf Spring Used in Cars
A leaf spring made up of steel, used in the back suspension system of the smaller passenger vehicle like car, is analyzed using analyzing software (ANSYS). By using the finite element analysis response, the stress induce...
Crack Depth and Crack Location Identification using Artificial Neural Network
Identification of crack depth and crack location is an area of concern for researchers across the globe. In the present paper, artificial neural network used to identify crack depth and crack location. Finite element mod...