Comparison Analysis of Zeta PFC Converter to Improve Power Quality Improvement by PI Controller, Hysteresis Controller and Fuzzy Logic Controller for Speed Control of Induction Motor
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 1
Abstract
This project “comparison analysis of ZETA PFC converter to improve power quality improvement by PI Controller, Hysteresis controller and Fuzzy logic controller for speed control of a Induction Motor”is composed of anisolated ZETA converter is proposed as a power factor correction (PFC) converter with DC link voltage control for speed control of a Induction Motor (IM).Induction motor has got the volatility of wide range of speed control.Power electronic converters canenvisage dynamic speed control. The front end rectifier and dc to dc converter can be monitored to facilitate requisiteinput voltage to the inverter fed drive working at constant speed. A single phase supply followed by an uncontrolledbridge rectifier and a Zeta DC-DC converter is used to control the voltage of a DC link capacitor which is lying between the Zeta converter and a Voltage Source Inverter (VSI). Speed control is achieved by maintaining constant dclink voltage. In this drive, speed is controlled by adjusting the DC link voltage of the VSI feeding induction motor.VSI operates in a low frequency switching mode for reduced switching losses. The voltage source inverter (VSI) is used as a stator supply of Induction Motor. The proposed converter performs the PFC action and DC link voltage control in single stage using only one controller. The current multiplier approach with average current control is used for operation of the isolated ZETA converter in continuous conduction mode (CCM). A rate limiter in the reference DC link voltage is designed for the control of current and torque in Induction Motor. The designed PFC converter results in an improved power quality at AC mains in a wide range of speed control and input AC voltage
Authors and Affiliations
V. Satya Narayana, J. N. Chandrasekhar
Keywords
Related Articles
- EP ID EP389048
- DOI 10.9790/1676-1201031118.
- Views 120
- Downloads 0
Mechatronic Modeling And Control of A Doubly-Fed Wind Turbine Induction Generator Using The Bond Graph Approach
This paper describes a Bond Graph modeling and control of a doubly-fed induction generator driven by a wind turbine and running at variable speed. This type of operation will retrieve at any time the maximum power regard...
Intelligent Secured Garage for Smart Buildings
Huge traffic in INDIA is due to improper parking system at various places like theatres, apartments, supermarkets etc. This forces the people to park their vehicle on roads. The present project work deals with the automa...
Approximate Mathematical Model for load profiling and demand forecasting
This paper describes the development of approximate mathematical models to be used in load profiling and forecasting, e.i., the household and commercial load profile. The model was developed by studying and profiling loa...
Simulation and Analysis of DC-DC Boost Converter Using Sliding Mode Controller under Variable Conditions
As the requirement of power increases, it is required to increase the generation on demand. Now a days, solar PV and wind are increasingly used for generation. The power collected from these energy source need to be conv...
Symmetrical Switching of a Three-Phase Rectifier to improve the power factor in the mini hydroelectric frequency control
his research analyzes a three-phase bridge rectifier, switches in series with the load switched symmetric angle, helping the effective current rates, active, reactive, apparent and distortion and power factor. The goal i...