COMPOSITES BASED ON MICROCRYSTALLINE CELLULOSE AND LUMINESCENT OXIDES: PROPERTIES AND A WAY OF APPLICATION
Journal Title: Machinery and Energetics - Year 2018, Vol 0, Issue 283
Abstract
Creation of the latest composite materials based on polymers and inorganic materials is one of the important directions of modern material science. When considering such composites, usually a polymer matrix and a filler are said, and their choice is dictated by the necessary physical characteristics. Among the polymer matrices, a special place is cellulose - the most common natural polymer that can be obtained from a variety of sources of plant material. As for inorganic filler, in this work several oxide materials were chosen which are luminescent-active. The composites thus produced may be suitable for use as fluorescent coatings in modern optoelectronic devices. The purpose of the study is the development of nanostructured composites based on cellulose, as matrix, and some complex oxides as fillers, and to find out their luminescence characteristics, which should confirm the forecasts for the possibility of their practical application. The results of luminescent spectroscopic studies of composites that consist of microcrystalline cellulose and oxides– AgNO3, K2Eu(PO4)(MoO4) and LaVO4:Sm are reported. It was established the luminescence properties of cellulose are dependent on type of plant raw materials as well as on processing methods. These factors have influence on luminescence intensity but profile of photoluminescence (PL) bands remains practically unchanged. A maximum of non-elementary PL band is located near 490 nm for case of excitation at 405 nm. Composites with argentums nitrate revealed similar shape of PL band with maximum at 490 nm but with more intensive short-wavelength side of the band. Under excitation in 337-532 nm spectral region the composites that contain K2Eu(PO4)(MoO4) and LaVO4:Sm are characterized by intensive visible photoluminescence. Spectra of these PL depend on excitation wavelength. It is shown the combination of luminescent coating “microcrystalline cellulose” + K2Eu(PO4)(MoO4)and commercial light emitting diode with λem = 455 nm allow to obtain bluish white light (chromaticity coordinates are x = 0.262; y = 0.224).
Authors and Affiliations
В. В. БОЙКО, В. П. ЧОРНІЙ, В. А. БАРБАШ, О. В. ЯЩЕНКО, О. М. АЛЄКСЄЄВ, Ю. Є. ГРАБОВСЬКИЙ, С. Г. НЕДІЛЬКО, Є. О. РЕЗНИЧЕНКО, М. С. НЕДЄЛЬКО
ВАРІАНТИ СТРУКТУРНИХ РІШЕНЬ СИСТЕМИ УПРАВЛІННЯ ТРАНСПОРТНИМИ ПОТОКАМИ ПЕРЕВЕЗЕННЯ ЗЕРНОВОГО ЗБІЖЖЯ
Для вирішення завдань управління необхідно застосовувати не тільки сучасні математичні моделі та методи управління, але і сучасні обчислювальні та телекомунікаційні засоби. Особливо це відноситься до того випадку, коли с...
АНАЛІЗ КІНЕМАТИЧНИХ ПАРАМЕТРІВ БОЛТОВОГО З'ЄДНАННЯ СІЛЬСЬКОГОСПОДАРСЬКОЇ ТЕХНІКИ
Запропоновано підхід до вивчення питання забезпечення необхідного технічного ресурсу болтового з'єднання на основі аналізу вібрації головки болта і гайки. Отриману графічну залежність енергії та потужності вібрації болто...
РЕЗУЛЬТАТИ ДОСЛІДЖЕНЬ НА ЯКІСТЬ РОБОТИ КОМБІНОВАНИХ АГРЕГАТІВ ДЛЯ ПЕРЕДПОСІВНОГО ОБРОБІТКУ ҐРУНТУ
Приведені результати досліджень по якості роботи комбінованих агрегатів на передпосівному обробітку ґрунту із застосуванням технічних засобів АРВ-8,1-02, УСМК-5,4В, “Європак 6000”, відповідно описані і показники їх робот...
АНАЛІЗ НЕУСТАЛЕНОГО ГРАВІТАЦІЙНОГО РУХУ ТА ХВИЛЕУТВОРЕНЬ СИПКОГО МАТЕРІАЛУ В ЄМКОСТІ ПРИ ЗМІННОМУ КУТІ ВНУТРІШНЬОГО ТЕРТЯ
Аналіз неусталеного гравітаційного руху та хвилеутворень сипкого матеріалу в ємкості при змінному куті внутрішнього тертя, всебічний аналіз неусталеного гравітаційного руху та можливих хвилеутворень сипкого матеріалу в є...
СРАВНИТЕЛЬНЫЙ АНАЛИЗ ХАРАКТЕРИСТИК ТЕЧЕНИЯ В ГОРЕЛКАХ С ЭШЕЛОНИРОВАННЫМ РАСПОЛОЖЕНИЕМ СТАБИЛИЗАТОРОВ ПЛАМЕНИ В ИЗОТЕРМИЧЕСКИХ УСЛОВИЯХ И ПРИ ГОРЕНИИ ТОПЛИВА
Приведены результаты компьютерного моделирования структуры течения в горелках с лестнично эшелонированными решетками стабилизаторов пламени для изотермических условий и реагирующих потоков. Проанализированы основные отли...