Comprehensive Analysis of Wire Electric Discharge Machining Process in 67 Machining High Chromium High Carbon Steel
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 1
Abstract
Every manufacturing industry primarily concentrates on yielding maximum profit with minimal expenditure where profit directly depends on the production cost and quality of the product. The firm aims at maximum production rate with minimum production cost and maximum surface quality. The minimal production cost and surface finish can be achieved by proper selection of combination of machining parameters, interaction study between of machining parameters and identification of the most contributing parameter for a specific response. Modern manufacturing industries have adopted different advanced machining processes for machining hard and difficult to machine materials. Wire Electric Discharge Machining process is the most adopted when considering machining of rectangle contour profile. The work mainly reflects on performance analysis of machining parameters in producing different contour shapes using Wire Electric Discharge Machining parameters. The consequence of the Machining parameters such as Pulse ON time, Pulse OFF time and MAO over the Machining time and Surface Roughness has been analyzed. The interaction study is made by Response Surface methodology. Analysis of Variance is used to identify the most significant parameters for the respective responses. The MAO had greater impact on Surface Roughness followed by Pulse ON time. The Pulse ON time was encountered as the most contributing parameter, for Machining Time. The average deviation between the empirical and predicted model for surface roughness was recorded as 0.03%, whereas 0.023% deviation was observed for Machining time. The regression model was developed for both Surface roughness and Machining time. Validation of models proved that, the developed models can be used to predict the responses.
Authors and Affiliations
S. DINESH, A. GODWIN ANTONY, K RAJAGURU, P. PARAMESWARAN
Keywords
Related Articles
- EP ID EP278679
- DOI 10.24247/ijmperdfeb20187
- Views 78
- Downloads 0
Stylistic Design Engineering (SDE) for an Innovative Green Vehicle Following QFD and TRIZ Applications
With this article, we intend to set the first strategic phase of the product development process, that is to say the one related to the conceptual project. In particular, this work refers to the installation of the proje...
Design and Simulation of Connecting Rods with Several Test Casesusing Al Alloys and High Tensile Steel
The connecting rods designed recently are made from cast iron and carbon steel, which possess less tensile strength, toughness and durability. To improve such concern, this work aims in designing and analyzing the connec...
Performance Evaluation of Solar Cooker Made from Locally Sourced Materials
This study describes the development and performance evaluation of a four reflector solar cooker, which was made from locally sourced materials. Teak wood was used in the construction of the solar box cooker with the dim...
An Optimisation of Spray and Performance Emission Characteristic of Biodiesel and its Blends by Varying Injection Timing in Diesel Engine
The main objective is to optimize the various parameters of spray for different blends of biodiesel and Injection pressure mainly with respect to Spray tip penetration Spray cone angle and Sauter Mean Diameter (SMD), usi...
INVESTIGATION OF MECHANICAL AND ELECTRICAL PROPERTIES OF KEVLAR/E-GLASS AND BASALT/E-GLASS REINFORCED HYBRID COMPOSITES
Composite materials are preferred as an alternate for traditional metals due to its admirable properties like chemically inactive nature, high strength to weight ratio, ease of fabrication and capability of tailoring int...