Conformal Band-Notch UWB Monopole Antenna on Finite Cylindrical Substrates
Journal Title: Engineering, Technology & Applied Science Research - Year 2013, Vol 3, Issue 3
Abstract
A microstrip-fed new UWB monopole antenna with a band-notch characteristic mounted on the finite cylindrical surface is presented. The proposed antenna consists of a rectangular metal radiation patch fed by a 50 ohm microstrip line and a rectangular ground plane. To achieve ultra-wideband, three modifications are introduced. The first one is to blend the upper and lower corners of the radiating plates. The second one is to remove a circular section from the radiating metal. The third one is to blend the upper corners of the ground plane. The antenna is designed on a substrate with dielectric constant εr=3 and 1.6 mm height. The proposed antenna is conformed on finite cylindrical substrates of radiuses 4, 5 and 6 cm. The cylindrical structures were simulated through CST microwave studio finite element package. The simulation results, obtained via CST package on the return losses, VSWR and radiation pattern of the antenna are presented. For both planar and conformal antennas, results show that the impedance bandwidth of the designed antenna is from 2-18 GHz with a return loss less than -10 dB (VSWR<2) and a band rejection of 5-6 GHz for wireless LAN (WLAN), that includes the band 5.15-5.825 GHz limited by IEEE 802.11.a and HIPERLAN/2 with return loss greater than -10dB. The proposed simple shaped conformal antenna provides a good radiation pattern and gain between 3.84 and 5.96 dBi over the entire frequency band excluding the rejected band.
Authors and Affiliations
E. S. Ahmed
Keywords
Related Articles
- EP ID EP89401
- DOI -
- Views 319
- Downloads 0
Relationship between Grain Size Distribution and Radon Content in Surficial Sediments of Wadi Arar, Saudi Arabia
Surficial sediments with low radon content are desirable materials in construction applications. In this study, the relationship between grain size and radon content was investigated in sediments collected from seven sit...
Numerical Study of the Thermal Behavior of a Composite Phase Change Material (PCM) Room
In this study, thermal performance of building walls integrated with phase change materials (PCM) was evaluated in terms of indoor temperature reduction and heat transfer time delay. PCM was incorporated as thin layer pl...
Controller Design For DFIG Driven By Variable Speed Wind Turbine Using Static Output Feedback Technique
This paper describes the controller design for a DFIG based wind energy generation system using the static output feedback technique through the LMI Toolbox. The features of the DFIG, its converters and their controllers...
Torque Ripple Minimization and Performance Investigation of an In-Wheel Permanent Magnet Motor
Recently, electric vehicle motoring has become a topic of interest, due to the several problems caused by thermal engines such as pollution and high oil prices. Thus, electric motors are increasingly applied in vehicle’...
Buckling of Hybrid Composite Carbon/Epoxy/Aluminum Plates with Cutouts
Structural instability becomes an important concern in the composite plate safe and reliable design. In this research, a resistance analysis is carried out on plates made of hybrid composite material with and without ell...