Conservative Management for a Traumatic Cervical Spine Cycling Injury
Journal Title: Journal of Science and Cycling - Year 2015, Vol 4, Issue 1
Abstract
Competitive cycling holds an inherent risk of traumatic injury often resulting in fracture. Questions regarding the probability of return to sport then arise. The purpose of this case report is to describe the treatment approach and likelihood of returning to cycling after traumatic fracture of the cervical spine and clavicle. This case report describes the use of an original combination of interventions for a C1 fracture with an associated open reduction internal fixation of a left clavicle fracture in a 39-year-old male cyclist. The patient lost control of his bike while descending a slippery slope and was propelled over the handlebars landing head first. The resultant cervical spine and clavicle fractures required twelve weeks in a cervical collar. Physical therapy interventions focused on regaining strength and functional mobility of the cervical spine and shoulder. Following treatment a minimal detectable change was seen for range of motion (>6%) of the cervical spine and shoulder, the Numerical Pain Rating Scale (3 point change), and the Disabilities of the Arm, Shoulder and Hand (29.2% change). The patient returned to his prior level of function at home and work. Medical clearance was received to return to training, with a hopeful prognosis of eventually returning to competition.
Authors and Affiliations
Rebecca Yde| Aurora BayCare Sports Medicine, Green Bay, USA, Kate Jochimsen| University of Wisconsin- Green Bay Athletic Trainer, Aurora BayCare Sports Medicine, USA, Jacklyn Goddard| Aurora BayCare Sports Medicine, Green Bay, USA
Keywords
Related Articles
- EP ID EP2900
- DOI -
- Views 422
- Downloads 25
Reliability and validity of PowerCal power distribution during cycling time trial
The PowerCal device (Cyclops, Madison, USA) is a heart rate (HR) strap that estimates power output (PO) using an algorithm computed from the HR response recorded during exercise. The device is a low-cost method (~ 99 US...
Wearable multi-sensor system for embedded body position and motion analysis during cycling
Purpose: The purpose of this study was to validate the AREM system in laboratory conditions. AREM is an embedded electronic system for motion tracking and movement analysis, based on Micro Electro Mechanical Systems (MEM...
The reliability of a 30-minute performance test on a Lode cycle ergometer
High retest reliability is desirable in tests used to monitor athletic performance. The purpose of the present study was to determine the reliability of a 30-minute cycle test on a cycle ergometer (Lode, Groningen, Nethe...
Treadmill cycling trial in diagnostics endurance preparation of MTB cyclists before Olympic Games or World Championship
The evaluation of endurance preparation of MTB cyclists in conditions corresponding to the specificity of routes of World Championship (WCh) and Olympic Games (OG) is very difficult. Treadmill cycling trials are used in...
Pedal force effectiveness in Cycling: a review of constraints and training effects
Pedal force effectiveness in cycling is usually measured by the ratio of force perpendicular to the crank (effective force) and total force applied to the pedal (resultant force). Most studies measuring pedal forces have...