Contact stresses on the rake face of cutting tools with PCBN in turning of hardened steel
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 1
Abstract
The paper presents the results of experimental study of determination of the geometric parameters of the contact zone of the chips with the rake face of cutting tools, as well as the shrinkage of chips during the final turning of hardened HVG steel by the tools from polycrystalline superhard materials with different contents of cubic boron nitride. Based on the experimentally established values of the cutting force components, a theoretical calculation of the level of maximum normal and tangential contact stresses for two types of tools: with high (BH) and low (BL) boron content has been conducted, and the nature of their distribution along the contact area of the chips with the rake face of the tools is shown. It is shown that during the turning of hardened HVG steel by the tool with composite of the BL group normal stresses up to 3.0 GPa arise in the contact zone and the tangential are 0,18 GPa at a cutting speed of 200 m/min, while turning by the tool with composite of group BH – 2,1 GPa and 0,58 GPa, respectively, at a cutting speed of 100 m/min.
Authors and Affiliations
S. A. Klimenko, S. An. Klimenko, A. Manokhin, Yu. Mel’nichuk, M. Kopіeikina
Keywords
Related Articles
- EP ID EP240065
- DOI -
- Views 75
- Downloads 0
The hypothesis of formation of the structure of surfaced metal at the surfacing based on the application of the prognostic algorithm of control the electrode wire speed
The growth of a drop in the process of surfacing by a consumable electrode is characterized by a linear dependence of the current change on time. A hypothesis has been put forward, according to which a reduction in the f...
Diamond Grinding the Ceramic Balls from Silicon Carbide
The influence of the machining regime was experimentally investigated on the output indexes of the diamond grinding the ceramic balls from silicon carbide, such as the rate of the material removal and the rate of changin...
Development of curvilinear blade impeller of vortex pump based on numerical simulation
The present paper focuses on study of relation between impeller outlet width and the slope of characteristic curve. In order to figure out this relation on the different operation modes the numerical simulation was used....
Selection of the Optimal Software for Designing Expert Systems
This article deals with the problems of information processing, searching and finding the solutions in the related fields of scientific knowledge. One of the solutions to this kind of problem is the software like expert...
Analysis of the gear tooth gearing by the module m = 2.625 mm of hydraulic pumps
The article deals with the method of finishing the cylindrical gears with diamond worm gear in mechanical engineering on a wide-universal milling machine. For processing, a special device has been developed, which provid...