Continuous Monitoring and SCADA Integration of the Sag of Overhead Electricity Transmission Cables Based on the Measurement of their Slope
Journal Title: ANALELE UNIVERSITATII DIN CRAIOVA - Seria Inginerie electrica - Year 2018, Vol 42, Issue 0
Abstract
This paper presents a proposed system for the continuous monitoring of conductor sag values in overhead electricity transmission lines through slope angle measurement, by using a mathematical model based on the catenary equation. By measuring the axial angle of the conductor and the slope angle by means of the double axis tilt sensor, the sag value can be calculated in case of cable swings. Using ModBus protocol the value of the tilt sensor can be read by the software application and the calculed sag value is send to SCADA. The results obtained according to the proposed algorithm developed in LabVIEW software environment showed that the system could meet the technical requirements for measuring conductor sag in electricity transmission lines.
Authors and Affiliations
Dumitru Sacerdotianu, Marcel Nicola, Claudiu-Ionel Nicola, Iulian Hurezeanu, Florica Lazarescu
Keywords
Related Articles
- EP ID EP433041
- DOI -
- Views 128
- Downloads 0
Modeling and Torque Ripple Control in Faulty SPMSM
This paper presents a model of a Surface Permanent Magnet Synchronous Motor which can be used in a faulty case and a torque ripple control approach developed to be applied if the faulty case is detected. Two faulty cases...
TIME-DOMAIN BASED ACTIVE COMPENSATION STRATEGIES UNDER NONSINUSOIDAL CONDITIONS IN THREE-PHASE THREE-WIRE SYSTEMS
This paper deals with the peculiarities involved by the operation under nonsinusoidal voltage conditions on the generation of the reference compensating current in three-phase three-wire shunt active power filters. The t...
Some Considerations Concerning Radiated Emissions Produced by a Board Display
The paper presents some considerations related to the radiated emissions from automotive area of interest. Firstly the equipment used for tests dedicated to radiated emissions is presented. Afterward some considerations...
POSSIBILITY FOR STUDY OF THE RELUCTANCE SYNCHRONOUS MOTORS DYNAMIC REGIMES
This paper presents a possibility for studying the dynamic regimes of the reluctance synchronous motors. There are detailed the mathematical model and the graphics obtained by simulation in certain dynamic regimes....
An Improved Numerical Model of Heat Transfer Coefficient Corresponding to a Through Connector
This paper is a continuation of a previous research in which was presented a method to determine heat transfer coefficient values corresponding to crimped connections. Because the differences between numerical values of...