Data Acquisition and Control Simulation
Journal Title: Acta Marisiensis. Seria Technologica - Year 2017, Vol 14, Issue 1
Abstract
The aim of this paper is to build a master application that controls a brake test system. One crucial step is developing a data acquisition and control system, capable of simulating the real physical stand. The simulator must supply data to the master application and signal the receipt of any instructions sent back to it. It is also means to support the development of a monitoring application to be run on mobile devices.
Authors and Affiliations
Traian TURC, Ioan MOCIAN
Experimental Model for a Brake Test Stand
A brake test stand is a mechanical system that simulates a driveway in order to test the efficiency of the braking system of an auto vehicle. It hosts a range of sensors and transmitters which measure the braking forces...
Mathematic Modeling of Experimental Results on the Influence of Technological Factors on Production in Some Energy Crops
The present article, based on data obtained from a study which analyzed the influence of technological and ecological factors on rape plants (Brassica napus) production capacity - the Bolero variety – approaches the mode...
Novel Hierarchical Micro/Nano Modified Surfaces for Dental Implants
Present paper presents the modification at nano scale level of the surfaces of Ti6Al4V alloy that were previously modified at micro scale level by acid etching (AE) or by sand blasting with large grit and acid etching (S...
Existence and Uniqueness of the Infinite Matrix Factorization LU
The purpose of this paper is to give conditions for the existence and uniqueness of the infinite matrix factorization LU.
Studying Transient State Using State Parameters
This paper presents the state variables method in the analysis of the transient state. Using this method the behaviour of transformers at on/off switching is studied. The transient state is a short event caused by any ch...