Data Recorder System for maintenance to Rotary Blade Machines – “HolderPPS”
Journal Title: Jurnalul Stiintific TURBO - Year 2017, Vol 4, Issue 1
Abstract
The HolderPPS system presented in this paper falls into the category of recording systems created for the proactive maintenance of rotary bladed machines. Based on an innovative architecture, the Holder-type system contributes to machine equipment diagnosis and to early warnings on potential flaws in the functioning of the machine. The system is able to determine, in real time, the causes of the warnings and of the emergency stops of the machine, in order to avoid any potential failures, or the rendering inoperative of the machine. These causes can be established by monitoring the critical parameters of the machine: vibrations, temperature, and quality of the lubricating oil. As such, data collected and processed on the basis of algorithms relating to high speed mechanical systems, allow local diagnosis of the current state of the machine, or data transfer, by remote connection, to a laboratory where an off-line analysis can be performed.
Authors and Affiliations
Filip NICULESCU, Constantin VILCU, Alexandru GAZDAC, Claudia BORZEA
Keywords
Related Articles
- EP ID EP268863
- DOI -
- Views 149
- Downloads 0
Optimising Low Speed Dynamic Balancing of High Speed Rotors
The research conducted revealed some particularities of the rotors manufactured and/or assembled at INCD Turbomotoare COMOTI. Different phenomena were encountered, named, and described, using data recorded while dynamica...
POWER CORRELATION OF DRIVING MOTOR FOR TURBO BLOWER WITH INDUSTRIAL PROCESS REQUIREMENTS
The turbo blowers are high-speed pneumatic bladed machines, great consumers of mechanical work. They are classified within the group of dynamic compressors, used for raising the pressure of gas. The turbo blower can be d...
Data Recorder System for maintenance to Rotary Blade Machines – “HolderPPS”
The HolderPPS system presented in this paper falls into the category of recording systems created for the proactive maintenance of rotary bladed machines. Based on an innovative architecture, the Holder-type system contr...
ADJUSTING THE RESONANT FREQUENCY OF A CANTILEVER PIEZOELECTRIC HARVESTER
The paper presents the methods employed for adjusting the resonant frequency of a piezoelectric harvester in cantilever construction, in order to meet the resonance condition with the vibration source. Operating at reson...
Simulation Segregaton in CMSX-4 Superalloy: Experiments and Simulation Predictions
The segregation degree of alloying elements during solidification in as-cast CMSX-4 singlecrystal superalloy was investigated. The elemental partition coefficients calculated using the results of experimental measuremen...