Decrease of surfaces roughness for parts processed with edge tool by improvement of the lathe working components uniform feed
Journal Title: Вісник Тернопільського національного технічного університету - Year 2017, Vol 88, Issue 4
Abstract
The relative motion smoothness of the tool and processing workpiece has an essential influence on the quality of the edge tool processing. The analyses of the process of the surface roughness formation on the parts processed with an edge tool under the influence of vibration movement of the metal-cutting lathes working components is carried out in this paper. The methods of prediction of the geometric parameters of the part surface quality are considered. It is determined here that the intensity of non-uniform metal-cutting lathe slide movement depends on the guide operating mode, that is, the conditions under which the friction of two surfaces occurs at their relative movement. Mixed friction influences the working components uniform motion the most negatively. In order to improve the uniform metal-cutting lathe support movement at light (fine) feeds it is suggested to go into guide dry (limiting) friction performing the processing with the additional loading of the working component. The results of the researches carried out under the working component loading connected with the influence of non-uniform support feed on the processed surface roughness are described. It was determined during the investigations that the stick-slip motion at light feeds of metal-cutting lathes working components is less intensive and the surface roughness of processed parts is improved
Authors and Affiliations
Yaroslav Stepchyn, Valentyn Otamanskyi
Keywords
Related Articles
- EP ID EP280392
- DOI 10.33108/visnyk_tntu2017.04.119
- Views 51
- Downloads 0
Hydrogen wear resistance under the metal-polymer friction pairs operation
The results of studies of labyrinth seals made of composite materials on the basis of aromatic polyamide phenylon reinforced by copper-carbon fiber are presented. It is shown that in this case a selective transfer with f...
Modification of drive roller chain link plates
The article deals with the problem of effect assessment on strain-stress state of drive roller chain link plates, their shapes and dimensions. It is noticed that decrease of strain concentration in plates cross-section d...
Automated system for irradiation of biologically active points of the human body
The automated system for the control of the absorbed energy dose of laser irradiation in the frequency range of modulation is developed and proposed.The possibility of choosing radiation frequencies with the maximum abso...
Analysis of the waste amount in mechanical engineering and metallurgy in Ukraine
Different metallurgical industries, which are characterized by formation of a large amount of wastes have been analysed. Most of them within the meaning of useful components are competitive in raw materials and can be us...
Fracture pecularities of prestressed steel reinforcement under hydrogenation in the model working medium
Pecularities of fracture behaviour of progressively drawn pearlitic steels from the initial hot rolled bar (not cold drawn at all) to the final commercial product (prestressing steel wire) were investigated in air and un...