Design And Analysis Of Trapezoid Ring Microstrip Patch Antenna For Lower Band 5G Application.
Journal Title: International Journal of engineering Research and Applications - Year 2017, Vol 7, Issue 10
Abstract
In 5G Technology, Lower Frequency 5G Band range from 3.4GHz to 3.6GHz (in India). Now days a lot of research is going on in the field of designing of 5G microstrip antenna. In this paper, a trapezoid ring microstrip antenna is designed and analysed its parameters for 5G Application. The dielectric material FR4 has been employed as a substrate material for designing the proposed antenna having thickness 1.6mm with relative permittivity (ɛr) of 4.3 with loss tangent (δ) 0.025. The microstrip line feeding technique with patch insertion has been used to feed the power to the antenna with proper impedance matching of 50Ω so maximum power can transfer. The trapezoid ring microstrip antenna performance has been analysed in terms of return loss (dB), gain (dBi), directivity (dBi) and VSWR, etc. The Computer Simulation Technology (CST) Studio Suite 2017 has been used for the analysis and simulation of trapezoid ring microstrip antenna.
Authors and Affiliations
Mukul Jain, Sarika Jain
Keywords
Related Articles
- EP ID EP392568
- DOI 10.9790/9622-0710051518.
- Views 84
- Downloads 0
A Review on Fluoride in Ground Water: Causes, Effects and Solutions
Water, the most vital resource for all kinds of life on this planet, is also the resource, adversely affected both quantitatively and qualitatively by all kind of human activities on land, in air or in water or naturally...
Fusion of Multispectral and Panchromatic Satellite Images in Environmental Issues
Image fusion of multispectral and panchromatic satellite image is used to combine spatial detail of the panchromatic image of high spatial resolution and spectral information of multispectral image of low resolution, in...
Performance Levels of RC Structures by Non-Linear Pushover Analysis
In the recent earthquakes in which many concrete structures have been severely damaged or collapsed, have indicated the need for evaluating the seismic adequacy of existing buildings. About 60% of the land area of our co...
Surface Finishing using Extrusion Honing Process on Monel- 400
Extrusion Honing (EH) also known as Abrasive flow machining (AFM) is a unconventional machining process which is used to deburr, radius, polish and remove recast layer of components in a wide range of applications by flo...
Power Factor Correction and Speed Control of BLDC Motor Drive Fed by Zeta Converter
This paper proposes a brushless dc (BLDC) motor fed by zeta converter for power factor correction (PFC). A single phase supply followed by an uncontrolled bridge rectifier and a Zeta DC-DC converter is used to control th...