Design and Development of Wireless Operated Low Cost Prosthetic Hand by Fused Deposition Modeling
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 1
Abstract
In present days, unfortunately, many of the people were losing their hands in different situations. The human body parts, which replaced by the artificial parts are known as prosthetic parts. Recently, the advent of 3D printers has enabled people to produce many inexpensive and obtainable prosthetics. This 3D printing technology is used because it takes less cost and manufacturing of hand should be accurate as per the design. In the present project, a low- cost wireless operated prosthetic hand developed with the help of fused deposition modeling. To validate the performance of the developmental prosthetic hand the No.of trial and error experiments conducted. The prototype was agreed some results and some experiments show the mixed results. The overall weight of the prosthetics is optimized and giving the desired functions at a t lowest weight than the normal bionics
Authors and Affiliations
BELLAM VENKATESH, MADALA AJAY KUMAR
Keywords
Related Articles
- EP ID EP279618
- DOI 10.24247/ijmperdfeb201843
- Views 75
- Downloads 0
THE EFFECT OF OBSTRUCTION ON PRESSURE DISTRIBUTION IN THE DIVERGENCE RIBS DUCT AN EXPERIMENTAL STUDY
An experimental study is carried out of two-phase flow phenomena around obstruction in a divergence rib rectangular duct for two opening divergence angles. The experiments are performed in the duct with the water - air f...
The CFD Analysis of Subsonic Flow Around Struts of Airfoil and Cylindrical Shape Attached to a Conical Diffuser at Exhaust of a Gas Turbine Engine
After burners are employed in an aero engine of a fighter aircrafts, to achieve maximum thrust during takeoff, climb and during some special combat maneuvers. Since the fuel consumption is high during the afterburning op...
DFM & Simulation for Injection Mould of Knob
This work deals with injection moulding simulation of Knob, in which the gate location, diameter and the possible defects during the filling& packing phase is determined and warpage effects under variable shrinkage with...
Analysis of Composite Orthogonal Grid Stiffened Flat Panel
Composites offer strength to weight ratio which is necessary for a aerospace industry. Commercial aircraft flooring is about 1cm thick, 2ft by 4ft in size and is made of glass or carbon fiber reinforced epoxy skins with...
A Method for Reducing the Tooth Profile Errors of the Spur Gears in the Hobbing Process
The gear hobbing process is one of the most common and economical methods to machine the involute gear. The tooth profile deviations of the hobbed gears were caused by machine errors, hob errors and the deviation of the...