Design and experimental and numerical verifications of the recirculating blower for long-term tests of turbine flowmeters
Journal Title: Archive of Mechanical Engineering - Year 2014, Vol 0, Issue 1
Abstract
A design of the centrifugal recirculation blower as well as results of its experimental and numerical investigations are presented in this paper. The blower was designed to work in the unique test stand which is used for long-term tests of turbine flowmeters. A 1D method was used to design this blower, then experimental and numerical studies were conducted in order to verify the 1D method. A comparison of the blower pressure increase obtained from the experiment and the computations is presented. Velocity and pressure distributions from the numerical simulations in selected sections are also shown and discussed. Additional numerical studies of a shrouded rotor and a rotor with a lower tip clearance were conducted and are presented in the paper as well.
Authors and Affiliations
Władysław Kryłłowicz, Krzysztof Sobczak, Michał Kuczkowski
Keywords
Related Articles
- EP ID EP165481
- DOI 10.2478/meceng-2014-0004
- Views 107
- Downloads 0
Modal measurements and model corrections of a large stroke compliant mechanism
In modelling flexure based mechanisms, generally flexures are modelled perfectly aligned and nominal values are assumed for the dimensions. To test the validity of these assumptions for a two Degrees Of Freedom (DOF) lar...
Collision-free trajectory planning for mobile manipulators subject to control constraints
A method of planning collision-free trajectory for a mobile manipulator tracking a line section path is presented. The reference trajectory of a mobile platform is not needed, mechanical and control constraints are taken...
Application of the strip yield model to crack growth predictions for structural steel
A strip yield model implementation by the present authors is applied to predict fatigue crack growth observed in structural steel specimens under various constant and variable amplitude loading conditions. Attention is p...
Experimental study and response surface methodology for investigation of FSP process
The article presents the effect of rotational and travelling speed and down force on the spindle torque acting on the tool in Friction Stir Processing (FSP) process. The response surface methodology (RSM) was applied to...
Implementation of a geometric constraint regularization for multibody system models
Redundant constraints in MBS models severely deteriorate the computational performance and accuracy of any numerical MBS dynamics simulation method. Classically this problem has been addressed by means of numerical decom...