Experimental and numerical investigation of radial forces acting on centrifugal pump impeller

Journal Title: Archive of Mechanical Engineering - Year 2014, Vol 0, Issue 3

Abstract

The paper presents the results of measurements and predictions of radial thrust in centrifugal pump with specific speed n_s = 26. In the pump tested, a volute with rectangular cross-section was used. The tests were carried out for several rotational speeds, including speeds above and below the nominal one. Commercial code ANSYS Fluent was used for the calculations. Apart from the predictions of the radial force, the calculations of axial thrust were also conducted, and correlation between thrust and the radial force was found. In the range of the measured rotational speeds, similarity of radial forces was checked.

Authors and Affiliations

Krzysztof Karaśkiewicz, Marek Szlaga

Keywords

Related Articles

Reliability assessment of a turbogenerator coil retaining ring based on low cycle fatigue data

Turbogenerator coil retaining rings are shrunk-fitted onto the rotor over the coils, in order to restrain them against the centrifugal force. They are typically subjected to low cycle fatigue, with a cycle being complete...

Tracking control of a balancing robot – a model-based approach

This paper presents a control concept for a single-axle mobile robot moving on the horizontal plane. A mathematical model of the nonholonomic mechanical system is derived using Hamel’s equations of motion. Subsequently,...

Structural and thermal analysis of automotive disc brake rotor

The main purpose of this study is to analyze the thermomechanical behavior of the dry contact between the brake disc and pads during the braking phase. The simulation strategy is based on softawe ANSYS11. The modeling of...

The accuracy of the reproduction of the lumbar spine elements following CT and MRI projections

The paper presents an analysis of factors influencing the accuracy of reproduction of geometry of the vertebrae and the intervertebral disc of the lumbar motion segment for the purpose of designing of an intervertebral d...

Application of the strip yield model to crack growth predictions for structural steel

A strip yield model implementation by the present authors is applied to predict fatigue crack growth observed in structural steel specimens under various constant and variable amplitude loading conditions. Attention is p...

Download PDF file
  • EP ID EP167383
  • DOI 10.2478/meceng-2014-0025
  • Views 85
  • Downloads 0

How To Cite

Krzysztof Karaśkiewicz, Marek Szlaga (2014). Experimental and numerical investigation of radial forces acting on centrifugal pump impeller. Archive of Mechanical Engineering, 0(3), 445-454. https://europub.co.uk/articles/-A-167383