Design and experimental characterization of a 350 W High Temperature PEM fuel cell stack
Journal Title: Frattura ed Integrità Strutturale - Year 2011, Vol 5, Issue 15
Abstract
High Temperature Proton Exchange Membrane (HT PEM) fuel cell based on polybenzimidazole (PBI) polymer and phosphoric acid, can be operated at temperature between 120 °C and 180 °C. Reactants humidification is not required and CO content up to 2% in the fuel can be tolerated, affecting only marginally performance. This is what makes HT PEM very attractive, as low quality reformed hydrogen can be used and water management problems are avoided. Till nowadays, from experimental point of view, only few studies relate to the development and characterization of high temperature stacks. The aim of this work is to present the main design features and the performance curves of a 25 cells HT PEM stack based on PBI and phosphoric acid membranes. Performance curves refer to the stack operating with two type of fuels: pure hydrogen and a gas mixture simulating a typical steam reformer output. The stack voltage distribution analysis and the stack temperature distribution analysis suggest that cathode air could be used as coolant leading to a better thermal management. This could simplify stack design and system BOP, thus increasing system performance.
Authors and Affiliations
Nicola Zuliani
Keywords
Related Articles
- EP ID EP140016
- DOI 10.3221/IGF-ESIS.15.04
- Views 91
- Downloads 0
Dynamic rock fragmentation: thresholds for long runout rock avalanches
The dynamic fragmentation of rock within rock avalanches is examined using the fragmentation concepts introduced by Grady and co-workers. The analyses use typical material values for weak chalk and limestone in o...
3D thickness effects around notch and crack tip stress/strain fields
Notches and cracks are usually approximately modeled as two-dimensional problems using solutions from plane elasticity to quantify localized stress/strain concentration effects around their tips. However, they may...
Sulla stima di macro, micro e nano-durezza di materiali metallici mediante analisi elasto-plastiche agli elementi finiti
Il lavoro sintetizzato nel presente articolo si pone come obiettivo primario quello di investigare la possibilità di stimare, mediante un approccio elasto-plastico agli elementi finiti, la durezza dei materiali met...
Effects of large amounts of hydrogen on the fatigue crack growth behavior of torsional prestrained carbon steel
The effects of large amounts of hydrogen on the fatigue crack growth properties of torsional prestrained ferritic–pearlitic low-carbon steel were investigated. Hydrogen-precharged specimens were produced by c...
Determination of fracture mechanics parameters on a base of local displacement measurements
New experimental technique for a determination of the stress intensity factor (SIF) and T-stress values is developed and verified. The approach assumes combining the crack compliance method and optical interferomet...