Design and Implementation of Astable Multivibrator using 555 Timer
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 1
Abstract
The 555 timer is widely used as IC timer circuit and it is the most commonly used general purpose linear integrated circuit. It can run in either one of the two modes: Monostable (one stable state) or Astable (no stable state). In the Monostable mode it can produce accurate time delays from microseconds to hours. In the Astable mode it can produce rectangular waveforms with a variable Duty cycle. The simplicity and ease with which both the multivibrator circuits can be configured around this IC is one of the main reasons for its wide use. The state of the art presented in the paper is the design and implementation of an Astable multivibrator using 555 timer IC, generating non-sinusoidal waveform in the form of Rectangular waveform as well as capacitor voltage waveform in the form of ramp waveform.
Authors and Affiliations
Md. Moyeed Abrar
Keywords
Related Articles
- EP ID EP389018
- DOI 10.9790/1676-1201022229.
- Views 168
- Downloads 0
Implementation of Wireless Hart Protocol Using Starter Kit DC9007
The wireless HART standard is the first open standard wireless communication standard for control and measurement in process industries. It uses secure time synchronized mesh networking with frequency hopping between the...
Performance Analysis of Wheeling Charges Determination Using Bialek’s Tracing Method Employing With IPFC Controller in Deregulated Environment
Transmission of electricity across the systems creates an essential link between the producers and consumers of the deregulated power sector. Transmission charges signify a minor proportion of overall operational expense...
Large Scale Industrial Temperature Monitoring and Control System using Lab View through Ubs (Manual and Automatic Modes)
the temperature monitoring and control system can be done in computer (PC) using Laboratory Virtual Instrumentation Engineering Workbench (LABVIEW) software. To obtain the quality of service in the industries, data acqui...
Design And Implementatio Of Multiloop Controllers For MIMO System
The objective of this paper is to design controllers for the TITO (Two Inputs and Two Outputs) system, the nonlinear system considered is quadruple tank process. In order to design the controller initially the work is st...
GA Based Controller for Autonomous Wind-DG Micro grid
A single renewable source of energy when integrated with other sources of energy it is termed as hybrid system. In this paper an active power control strategy has been developed such that when the wind alone is not able...