Thermal Analysis of Laptop Battery Using Composite Material
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 3
Abstract
The main objective of this paper is to reduce the heat produced in the Battery. A composite material is placed over the battery to absorb the heat produced in the internal cells and outer casing. The temperature of the battery is analyzed using ANSYS15.0 software. The simulation result is compared with the cooling methods of cooling fans, heat sinks and fins. According to the simulation result, the proposed method is better effective in cooling the batteries. Overheating in laptop leads to failure of hardware components and decrease the lifespan of the computer. This thermal management of laptop battery using composite material reduces the temperature up to 47°∁ with better thermal efficiency. Due to the reduction of temperature in the battery, there is a considerable reduction in charging time of the battery and also it avoids the fast discharging in batteries.
Authors and Affiliations
R. Arun kumar
Power Flow Control And Total Harmonic Distortion Reduction In HVDC Link Using PI And ANN Controllers
Long distance AC transmission is often subjected to certain problems which limit the transmission capability. HVDC is a better option for transmission of power over long distances. Power is being transmitted between two...
Accurate Dielectric Capacitance Determination from MetalInsulator-Semiconductor Devices Having Bias and Frequency Dependent Conductance Due To Leakage Current
A model for MIS device in accumulation is proposed which includes a bias and frequency dependent conductance in parallel with the insulator capacitance due to the leakage current. The model is validated by experimental r...
DC To DC Boost Converter with High Voltage Gain
the main objective of this work is to produce a very high DC output voltage from a small input voltage. The input voltage range is from 4 to 6 DC voltages and the output voltage is 810 V with no load. Depending upon the...
Wireless Energy Harvesting Using RF-Dc Module
This project presents an optimization of the Voltage doubler circuit in an energy conversion module for Radio Frequency (RF) energy harvesting system at both 900 MHz and 900Hz band. The function of the energy conversion...
Dendrite Growth Model at Bonded (001) GaAs Interface
A periodic GaAs wafer-bonded structure was used for nonlinear optical device. Results showed voids present at the bonded GaAs twin boundary. These voids were caused by natural topographical irregularities and surface con...