Design and Implementation of Op-Amp Based Low-Power CMOS Bandgap Voltage Reference with Minimum Supply oF 0.8-V
Journal Title: Bonfring International Journal of Power Systems and Integrated Circuits - Year 2013, Vol 3, Issue 2
Abstract
A low power voltage source is generated by altering the device size in existing topology has been presented. Bandgap voltage reference is generated by combination of start-up, supply independent, operational amplifier (Op-amp) and bandgap core circuits which has been designed such that low sensitivity of temperature and supply variation. It has been designed with minimum supply of 0.8 V without use of low threshold device, and the maximum supply current is 35 ?A. It has been implemented in 180 nm standard digital CMOS Process. The circuit generates a reference voltage of 540 mV and has a temperature coefficient of 14 ppm /?C from −40 ?C to 120 ?C. The generated reference voltage is independent of temperature and supply variations have been mathematically proved by analyzing the circuit design. Also, proper selection of on-chip passive components and its values has been chosen which is based on low noise. Comparing the pre and post layout simulation results has been presented.
Authors and Affiliations
Arivazhagan P
Keywords
Related Articles
- EP ID EP94159
- DOI 10.9756/BIJPSIC.10229
- Views 141
- Downloads 0
Impact of Elliptical Cross-Section on Some Electrical Properties of Gate-All-Around MOSFETs
Silicon (Si) Gate-All-Around (GAA) MOSFETs offers full electrostatic control over the gate which makes them promising candidates for the next generation complimentary metal-oxide-semiconductor field-effect transistors (C...
Reliability Analysis of Distribution Automation on Different Feeders
Automating a distribution system is an effective means to provide a more reliable and economical system in the fast growing technological world. This paper delivers into automating a system using two- stage restoration (...
Modelling of Solar Still Using Granular Activated Carbon in Matlab
In the last years the demand for fresh water is increasing tremendously all over the world. The future demand will be very high and the fresh water resources are getting depleted at a faster rate. We need to depend on th...
Investigation and Simulation of Phase to Ground Fault in DFIG based Wind Turbine System
With advent of wind farms in large scale and capacity continuously increasing, issues related to performance of the overall system needs to be addressed. Faults produced by wind turbine generator systems will impact not...
Automatic Gas Valve Control System using Arduino Hardware
In this paper, the automatic gas valve control system is designed using arduino hardware. Arduino is an open hardware platform that provides a rapid prototype development. A servomotor is fitted to a gas valve. Four cont...