Design and Thermo Structural Stress Analysis of Axial Flow Gas Turbine Blisk
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 6
Abstract
Several challenges to control the vibration in turbine blades. Due to high turbine inlet temperature and vibration has been found in mechanical industries. Blisk or integrally bladed rotor has been used in the compressor engines Applied the thermal and mechanical loads on disk and turbine blades. Inconel 718 and CMSX-4 are the materials, chosen for the disk and the blades of blisk. The thermal analysis is first carried out in patron/ MSC Nastran. Thermal stress and thermo structural analysis is done for the blisk. OBJECTIVE: The objective is to design an axial flow gas turbine blisk and perform thermo structural analysis of the turbine blisk.
Authors and Affiliations
Saleem M, J Udhyaprakash
Keywords
Related Articles
- EP ID EP252482
- DOI -
- Views 90
- Downloads 0
A REVIEW ON DIESEL INJECTORS MODELING, SPRAY AND CAVITATION
This abstract is a literature review makes use of computational fluid dynamics (CFD) codes to model the incylinder fluid flow on a common rail direct injection diesel engine, turbulence and spray characteristics using fu...
Static Structural Analysis of Go-Kart Chassis
The study on rule book prescribed for Go-kart, designing the kart according to the arrangement of all parts is presented in this paper. Through different design events, students can show interest towards designing and an...
Thermo structural Analysis of Structural Plates
This paper aims the evaluation of the thermal réponses, stresses, deformations and frequencies for Structural Steel and Aluminum. Thermal, Static, Modal and Random vibration analysis are performed on the plates for Struc...
An Effect of Welding Type on the Mechanical Properties of Welding Joints
Welding is widely used in the construction of metallic structures. In service, these structures are prone to failure under different types of loadings: static and dynamic. A welding joint should have adequate strength to...
Eliminating Wrong Spot Welding by Robots in Production Line
The main objective of our project is to reduce the false seam joints. There are many important issues, such as waiting for a lost robot, checking individual parts, unnecessary manual nutrition and increasing the cycle ti...