Determination of Glass Transition Temperature for Polyester / Graphene Oxide and Polyester / Graphite Composite by TMA and DSC
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2015, Vol 38, Issue 2
Abstract
The influences of oxide grapheme and grapheme in thermosetting polymer composites are complex and they very much depend on the chemical bonds formed between the additives and the polymer matrix. This study has used polyester as polymeric matrix and oxide grapheme and graphite as additives. Determination of glass transition temperature (Tg) is important for practical uses of polyester composites due to the changes of characteristics triggered by transition, thus the polymer passes from elastic to plastic state. In order to determine the Tg we used TMA, DSC, DMA tests. The differences in determined Tg values for the same composite are due to different measurements as resulted from each test.
Authors and Affiliations
Marian BAȘTIUREA, M. S. BAȘTIUREA, Gabriel ANDREI, M. MURARESCU, D. DUMITRU
Keywords
Related Articles
- EP ID EP581379
- DOI -
- Views 92
- Downloads 0
Experimental Equation of Deformation Behaviour of a Concrete Steel
The plastic deformation behavior is defined by the function of the deformation strength according to the strain, strain rate and temperature as the factor of the deformation process. The behavior law establishes by the e...
Study of the ThermoMechanical Treatment Post-Deformation Maintaining Time Influence on the Mechanical Characteristics of the MicroAlloyed Steels
This paper-work shows the results of the laboratory researches of the postdeformation maintaining time influence on the physical-mechanical characteristics of the flat microalloyed steels, at high temperature thermomecha...
Residual Stress and Tribology Behaviour of TiCx Coating Deposited by NPCVD Method
In this paper, thin TiCx films were coated by chemical vapour deposition method, and various duty cycles were carried out in order to observe the influence of this parameter on residual stress and tribology behaviours. T...
Industrial Electron-Beam Equipment on Base of Noble and Non-Ferrous Metals
Method of obtaining of metals and alloys by melting – is basic. By this way make in practice the majority of metals, alloys and ligatures. The essence of a method is, that in special melting device (furnace) to melt meta...
A Thermodynamic Contact Problem for Elastic-Viscoplastic Materials
Mathematical modeling of stress generation and heat transfer in casting processes is a difficult and complex subject that is now receiving increased attention. In this paper, we study a dynamic problem which describes th...