DETERMINATION OF INSULATION PARAMETERS OF CURRENT TRANSFORMERS AT MULTIPLE MEASUREMENTS IN MONITORING SYSTEMS UNDER WORKING VOLTAGE
Journal Title: Електротехніка і Електромеханіка - Year 2016, Vol 0, Issue 5
Abstract
Features of the data processing procedures of multiple measurements of the dielectric loss tangent of the high-voltage insulation, which are based on the comparison method, were considered. Three procedures were compared: the one procedure uses an assignment of a particular standard object for comparison, and two procedures don't use assignments of the special standard objects. Expressions of methodical errors of studied procedures were obtained. Analysis and calculations, which use the obtained expressions were made. Evaluations showed that an influence of a change of the tangent of dielectric loss of one from the monitoring objects on results of estimation of the tangents of other monitoring objects is the distinctive feature of the procedures without assignment of the standard object. Errors of these procedures more than errors of the traditional procedure, with assignment of the standard object. The study demonstrated that procedures without assignment of standard objects lead to difficultly predictable methodological errors, which hinder to estimate the actual value of the loss tangent and to estimate outcomes of the monitoring, by means comparing with allowable values. Moreover, the decrease of estimations of loss tangents of all objects, as a result of occurrence of at least one the object with strongly bad parameters, hides occurrence of other unsuccessful objects with smaller deviations and makes difficult recognition of such deviations at early stages. Improvements in processing techniques which reduce earlier specified errors and reduce the amount of measurements are proposed. The study results are useful in monitoring and diagnostic of basic insulation of current transformers or high-voltage bushings.
Authors and Affiliations
V. K. Beliaev, H. N. Panenko
Keywords
Related Articles
- EP ID EP297721
- DOI 10.20998/2074-272X.2016.5.06
- Views 113
- Downloads 0
AN ANTHOLOGY OF THE DISTINGUISHED ACHIEVEMENTS IN SCIENCE AND TECHNIQUE. PART 42: ELECTRONICS: RETROSPECTIVE VIEW, SUCCESSES AND PROSPECTS OF ITS DEVELOPMENT
Purpose. Preparation of brief scientific and technical review about sources, retrospective view, basic stages, achievements, problems, trends and prospects of development of world electronics for period of 20th-21st cent...
COMPONENTS OF THE TOTAL POWER LOSSES IN THREE-PHASE ENERGY SUPPLY SYSTEMS WITH SYMMETRIC SINUSOIDAL VOLTAGE SOURCE
Purpose. Three-phase energy supply system with a symmetrical resistive load operates in mode with the highest possible efficiency in a case of zero instantaneous reactive power and the absence of pulsations instantaneous...
MATHEMATICAL MODELING OF ELECTROMECHANICAL PROCESSES IN A BRUSHLESS DC MOTOR
On the basis of initial assumptions, a mathematical model that describes electromechanical processes in a brushless DC electric motor with a salient-pole stator and permanent-magnet excitation is created.
APPLICATION OF A RELATIVE TECHNICAL LEVEL INDEX METHOD TO INDUCTION MOTOR OPTIMIZATION PROBLEMS
On the basis of a method of relative technical level indices with relative geometric controlled variables, analytical expressions are derived to determine the optimum geometric dimensions of the squirrel-cage induction m...
EXPERIMENTAL RESEARCH OF MAGNETIC FIELD SENSORS SPATIAL ARRANGEMENT INFLUENCE ON EFFICIENCY OF CLOSED LOOP OF ACTIVE SCREENING SYSTEM OF MAGNETIC FIELD OF POWER LINE
Purpose. Experimental research of magnetic field sensors spatial arrangement influence on efficiency of closed loop active screening system by magnetic field of high voltage power lines developed a three-phase single-cir...