Determination of Wood Fractional Composition Effect on Gasification Process
Journal Title: Energy Engineering and Control Systems - Year 2016, Vol 2, Issue 1
Abstract
The heating value of synthesis gas derived as a result of the fuel gasification can vary depending on various factors. The main factors that affect the process of gasification is the fractional composition of wood; the amount of air fed to the gasification chamber; the height of the active layer and a series of other factors, dependent on fuel which is gasified and parameters of the gasifier. Any type of wood has to be to ground up for subsequent thermal processing. Depending on the production necessity, wood is ground up to technological chips of different fractions by chipping machines (also called wood chippers, shredder). The choice of chippers type depends on the need. Modern chipping machines allow making fine tuning of the source material by wood size. Considering the deficit and cost of energy carriers to the forefront using waste of wood chippers as fuel for gas-generator installations and solid fuel boilers.
Authors and Affiliations
Stepan Lys, Yosyph Mysak, Taras Kravets
Keywords
Related Articles
- EP ID EP256958
- DOI 10.23939/jeecs2016.01.005
- Views 86
- Downloads 0
Improvement of Pulse-Width Modulation Algorithm for Thermal Plant Control
The results of the pulse-width modulation algorithms analysis are presented in the paper. The following two algorithms are analyzed: pulse-width modulator (PWM) based on the sawtooth waveform generator and PWM based on a...
Techniques for Natural Gas Physical Properties Definition for Flow Rate and Volume Metering Systems
The results of researching the techniques for natural gas properties determination for flow rate and volume metering systems are presented in the paper. The necessity of developing techniques for calculating the isentrop...
The Method of Signal Processing when Measuring Non-stationary Values
Nowadays the problem of quick-changing non-stationary values measurement is extremely actual in various modern technical systems (parameters control of engine combustion chamber, testing of aerospace complex products, sc...
Investigation of Mill Balls Metal Deterioration in Mills KBM 370/850 (Sh-50А) when Fuel not Envisaged in the Mill Design is Used at Thermal Power Plants
Method for determining mill balls metal deterioration rate in a ball mill KBM 370/850 (Sh-50А) of dust-system of coal-dust boilers TPP-210А and TPP-312 300МW of thermal power plants is described in the paper. The researc...
Optimization of Gas Dynamical Subsystem of Transducers for Measurement of Gas Flow Temperature
The main types of errors which occur while measuring the temperature of gas flows, including flows of fuels, are determined by the conditions of thermal balance at the interaction of the sensor of the temperature transdu...