Determination the effect of cutting parameters on surface roughness in turning of 16MnCr5 steel using Taguchi technique
Journal Title: JOURNAL OF ADVANCED RESEARCH IN MECHANICAL ENGINEERING AND TECHNOLOGY - Year 2014, Vol 4, Issue 3
Abstract
In this research work an attempt has been made to try to investigate the effects of cutting parameters such as feed rate cutting speed and depth of cut on surface roughness in turning operation of 16MnCr5 steel, is a case hardening steel with by the support of Taguchi technique.An orthogonal array, signal to noise (S/N) ratio and analysis of variance (ANOVA) were used to determine the effects and contributions of cutting speed, feed rate and depth of cut on the response variable.turning operations were carried out by Tungsten carbide coated cutting tool inserts. The experiments were conducted at three different cutting speeds (400, 600 and 800 rpm) with three different feed rates (0.06, 0.12 and 0.18 mm/rev) and a constant depth of cut (0.5, 1.0 and 1.5 mm). The cutting parameters are optimized using signal to noise ratio and the analysis of variance.obtained result data revelled that depth of cut has most significant effect over surface roughness followed by cutting speed while feed rate has lowest effect.
Authors and Affiliations
Mr. Saadat Ali Rizvi
Keywords
Related Articles
- EP ID EP222446
- DOI 10.24321/2454.8650.201701
- Views 132
- Downloads 0
Usage of Additive Manufacturing Techniques in Producing Orthotic Insole
Usage of 3 D printed objects has gained a huge interest in recent years. This has led to a variety of 3 D printed ready to use products in today’s market. In this review paper, the usage and testing of 3 D printed orthot...
In-Built Coolant Cooling System
The objective of this paper is to present the new technologies, innovations and trends in the area of automobile cooling and automobile air conditioning and cooling system, which is fast and very effective. The advanceme...
Mechanical Behaviour of Fly Ash Reinforced Aluminum Composite Prepared by Casting
Fly ash is a waste residual material generated by coal burning in thermal power plants, steel plants etc.; its hazard is no less than that so utilizing fly ash in engineering applications is a service to society. Thus de...
Analysis Of Heat Generation During Friction Stir Processing of Aluminium Similar Joints
In this paper, the study of heat generation during friction stir processing of similar joints of AA6061-T6 is carried out. A three dimensional (3D), transient, a non-linear thermal model was developed using ANSYS 16.2 so...
Elastoplastic Analysis of a Metallic Mast with Stiffeners, Experimentation and Numerical Simulation
This work entitled - Elastoplastic Analysis of a Metallic Mast with Stiffeners - is devoted to optimize the weight of masts. These masts are made of steel and have a conical geometry with constant thickness. The masts ar...