Elastoplastic Analysis of a Metallic Mast with Stiffeners, Experimentation and Numerical Simulation
Journal Title: JOURNAL OF ADVANCED RESEARCH IN MECHANICAL ENGINEERING AND TECHNOLOGY - Year 2017, Vol 4, Issue 4
Abstract
This work entitled - Elastoplastic Analysis of a Metallic Mast with Stiffeners - is devoted to optimize the weight of masts. These masts are made of steel and have a conical geometry with constant thickness. The masts are considered clamped at their lower basis in soil. The masts should resist to the applied loads which are self weight, wind and equipments. Firstly, two types of design have been proposed to pursue this study; Type A consists of adding longitudinal stiffeners and type B consists of changing the whole shape of the masts section. Deflection tests will be applied to the type A of masts according to the metallic standards, these same tests will be applied also on normal masts. The test results will be analyzed to study the effects of the stiffeners on the mechanical behavior of the masts. Many computational cycles are realized by a numerical software to prove that we have the same results on the type A masts either by experimental tests or numerical simulation, hence, we will analyze the mechanical behavior of type B by using only the mumerical simulation method. The results have shown that both type A and type B allow a considerable weight optimization. Finally, an analysis of the two solutions proposed will be done in order to determine the advantages and disadvantages of each one of them.
Authors and Affiliations
Mohammed Amine Dirhar
Keywords
Related Articles
- EP ID EP269248
- DOI -
- Views 152
- Downloads 0
Determination the effect of cutting parameters on surface roughness in turning of 16MnCr5 steel using Taguchi technique
In this research work an attempt has been made to try to investigate the effects of cutting parameters such as feed rate cutting speed and depth of cut on surface roughness in turning operation of 16MnCr5 steel, is a cas...
Experimental Study For Heat Transfer Enhancement of a Radiator using Twisted Inserts with Different Coolants
The radiator is used for cooling the internal combustion engine cylinder with the help of different coolant fluids. It is an essential part for any IC engine for its proper and smooth operation. In radiator the coolant f...
Design Development and Analysis of Various Component of Four Wheel Drive
This paper concentrates on explaining the Design and Analysis aspects of making a Go Kart for Students Kart Design. This report explains objectives, assumptions and calculations made in designing of Go Kart.
Comparison of Experimental and Simulation Studies on Thermal Stratification in a Thermal Energy Storage System
Renewable energy supplies are steadily gaining increasing importance in all the countries. In particular, solar energy being non-polluting, clean and inexhaustible has received wide attention among scientists and enginee...
Computational Analysis for Random Winglet Designs on Light Aircraft
This paper describes 3-dimensional wing-winglet analysis that was performed on random winglet designs on varying cross-sections of air foil. A total of four random wing-winglet pairs have been studied and their performan...