Determining the force function distribution in the working zone of a disk magnetic separator
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 5, Issue 5
Abstract
The paper reports a research into the distribution of magnetic force function in the working zone of a newly-designed disk separator, intended to clean the finely-dispersed bulk substances, transported by a belt conveyor, from unwanted ferromagnetic impurities. It has been shown that it is expedient, in order to create the required magnetic field topology in the working volume of the separator and to improve its energy efficiency, to use permanent magnets. It has been substantiated that the main advantage of the proposed device on permanent magnets is a possibility to self-clean the surface of a non-magnetic rotating discharge disk. Solving the main tasks of this research has employed a finite-element method implemented in the programming environment COMSOL Multiphysics. We have investigated a magnetic force function that acts on multi-domain ferromagnetic particles. Given the complexity of the spatial geometry of power field distribution in the working zone of a disk magnetic separator, we have constructed a three-dimensional model of the magnetic system. The effect of the magnitude of an air gap and, accordingly, the effective length of sector-like permanent magnets on the distribution of power magnetic function in the working zone has been determined. It has been shown that changing the air gap alters both the force function distribution for the height of the working zone and the magnitude of the power action. Recommendations have been given on the use of magnetic systems with different gaps. It has been established that for the extraction of ferromagnetic inclusions the uniformity of the force function distribution in the direction of deploying a spiral of magnets is important. It has been proven that magnetic systems with small gaps should be used in separators without an unloading disk. In this case, the magnetic system can be installed in close proximity to the separated material while the surface of permanent magnets should be carried out manually in proportion to the accumulation of the extracted ferromagnetic inclusions on them. The result of our study is the established rational size for an air interpolar gap, which ensures the maximum magnitude of power action and, consequently, a more efficient operation of the magnetic separator
Authors and Affiliations
Iryna Shvedchykova, Inna Melkonova, Hryhorii Melkonov
Keywords
Related Articles
- EP ID EP667135
- DOI 10.15587/1729-4061.2019.181043
- Views 85
- Downloads 0
Devising methodological provisions for the comparative evaluation of variants for an armament sample in terms of military-technical level
<p>When setting a tactical-technical task on constructing a sample of armament, not only its characteristics related to purpose are considered, but its operational and technical, technological, economic, and other charac...
The objectified procedure and a technology for assessing the state of complex noise speech information protection
<p>White noise generators are typically applied for the systems of active interference in the design of systems for protecting verbal information. The level of speech information protection against leaking through acoust...
Studying truck transmission oils using the method of thermal-oxidative stability during vehicle operation
<p>Development of technical maintenance of transport means consists in providing their technical state at a significant level of functional operability for which the use of quality lubricants is a key requirement. Theref...
Effect of quench and temper on hardness and wear of HRP steel (armor steel candidate)
<p>The need for quenched and tempered steel increased, especially for the manufacture of the combat vehicle components. This steel is classified as high-strength and hardness and is bullet-resistant steel (armor steel)....
Research into the process of multi-level management of enterprise production activities with taking risks into consideration
<p>The study considers the process of management of the production activity of an enterprise during a certain interval of time. It takes into account components of the production process and an influence of various produ...