Development of Fault Diagnosis System for Automatic Lubrication of Power Flat Transport
Journal Title: 河南科技大学学报（自然科学版） - Year 2017, Vol 38, Issue 3
Abstract
In view of the shortcomings of the existing automatic lubrication system,such as high failure rate and backward diagnosis technology,a fault diagnosis method of lubrication system based on fault tree analysis combined with expert system was proposed. By analyzing the fault mechanism of the 125-type power flat transport vehicle lubrication system,the fault tree was established and taken as a diagnostic model to construct the knowledge base. Combined with the corresponding algorithm,the fault diagnosis and location were realized.The experimental results show that the method can realize the monitoring and fault diagnosis of the lubricating system.
Authors and Affiliations
Run LIU, Linjian SHANGGUAN, Linxiao YAO, Hongli YUN, Song WU
Keywords
Related Articles
- EP ID EP478035
- DOI -
- Views 88
- Downloads 0
Application of Interval Random Frog Combined with Sucessive Projections Algorithm to Detecting Nitrogen Content in Rubber Tree Leaves
The non-destructive detection method of nitrogen content in rubber tree leaves based on visible/near infrared spectroscopy was studied.A total of 176 rubber tree leaf samples were collected, and the visible/near infrared...
Laboratory Test of Silt Clay Consolidation by Vacuum Preloading
The consolidation effect of soil after vacuum preloading method was very different by depth. In order to explore the reason of vacuum degree loss during vacuum transfer via vacuum preloading method,the silt clay was used...
Stress Relaxation Behavior of Al_2O_3/ Cu Dispersion Strengthened Copper Alloy
The stress relaxation behavior of Al_2O_3/Cu dispersion strengthened copper alloy at different temperature( room temperature,100 ℃,200 ℃ and 300 ℃) was studied by the stress relaxation experiment.The test data were fitte...
Ultrasonic Phased Array Testing and Probability of Detection Quantitative Analysis of Polyethylene Pipe Butt Fusion Joints
The customized polyethylene test block was designed with transverse hole defects at depths of 10 mm, 15 mm, 20 mm, 25 mm, 30 mm, 35 mm, 40 mm, whose diameters were 1 mm and 2 mm respectively. Then probability of detectio...
Effect of Powder Metallurgy on Microstructures and Mechanical Properties of Sn2.5Ag0.7Cu0.1RE Lead-free Solder
Based on the powder metallurgy ( PM) process design of low-melting Sn2. 5 Ag0. 7 Cu0. 1 RE alloy, the effects of compacting and sintering on the microstructure and mechanical properties of the solder alloy were studied....