Development of Nationwide Vs30 Map and Calibrated Conversion Table for Indonesia using Automated Topographical Classification
Journal Title: Journal of Engineering and Technological Sciences - Year 2017, Vol 49, Issue 4
Abstract
A nationwide Vs30 map for Indonesia was developed based on automated topographic classification from 90-m grid digital elevation data and their correlation with Vs30. Automated topographic classification has been proposed by Iwahashi and Pike (2007) and a procedure to convert topographic class into Vs30 maps has been developed by Imamura and Furuta (2015) based on Vs data from J-SHIS (Japan Seismic Hazard Information System). In order to be suitable for Indonesia, calibration work according to Imamura and Furuta’s procedure should be conducted since the geotechnical conditions in Japan may not be the same as in Indonesia. This paper presents adjustment of the Vs30 correlation by Imamura and Furuta to convert topographic class into Vs30 and construct a Vs30 map of Indonesia. This correlation was calibrated by using Vs data from BMKG (Indonesian Agency for Meteorological, Climatological, and Geophysics) as well as standard penetration test logs that were collected by the authors. Utilization of local field measurement data will certainly enhance the reliability of the Vs30 map. The developed nationwide Vs30 map will be very useful for disaster mitigation programs and for preliminary design of earthquake resistant buildings and infrastructure in Indonesia.
Authors and Affiliations
Masyhur Irsyam
Keywords
Related Articles
- EP ID EP324058
- DOI 10.5614/j.eng.technol.sci.2017.49.4.3
- Views 99
- Downloads 0
Synthesis of Acrolein from Glycerol Using FePO4 Catalyst in Liquid Phase Dehydration
Acrolein is currently produced using propylene from crude oil while its price and scarcity are increasing. A renewable material such as glycerol is an attractive alternative for acrolein production. It can be obtained fr...
Study of Micro-hardness of High-Speed W9Mo4Co8 Steel Plates in Pendulum Grinding by Abrasive Wheel Periphery
In cutting tool assembly, grinding is the most important technological step of the finishing treatment, largely determining the workmanship. An increase of micro-hardness after grinding relative to the original one indic...
Three-Dimensional Gravity Inverse Modeling for Basement Depth Estimation Integrating Maximum Difference Reduction (MDR), Trend Surface Analysis (TSA) and Total Variation Regularization
In sedimentary basin studies, gravity data are typically used to estimate the basement topography. Gravity inversion methods are expected to be able to discriminate between continuous and discontinuous sedimentary basins...
The Distribution of Microalgae in a Stabilization Pond System of a Domestic Wastewater Treatment Plant in a Tropical Environment (Case Study: Bojongsoang Wastewater Treatment Plant)
The Bojongsoang Wastewater Treatment Plant (WWTP) serves to treat domestic wastewater originating from Bandung City, West Java, Indonesia. An abundant amount of nutrients as a result of waste decomposition increases the...
Potential of Reinforced Indonesian Glulam Beams Using Grade I (Bengkirai), Grade II (Kamper), Grade III (Nyatoh) Woods for Use in Structural Wood Design
Wood is a natural resource that is renewable and available in various species in tropical countries. Its abundancy in nature makes it easy to obtain, thus making it a nature friendly material for use in construction. Ind...