Directions of the environmental protection processes optimization at heat power engineering enterprises
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 2
Abstract
The article observes the impact factors of heat power engineering enterprises on the environment and ways of anthropogenic impact reduction during the application of ecological security control technological methods. The authors suggest attending to the optimization of specific environmental protection processes during the elaboration of ecological security control technical methods in order to reduce the anthropogenic impact on the environment. At the industrial enterprises it is reasonable to implement the principle of the optimization of the environmental protection processes with the help of the high-intensity purification equipment. The optimization of the environmental protection process involves the choice of the physical-chemical factors such as: thermodynamic, kinetic, mass- and heat-exchanging, hydrodynamic, influence parameters on the heterogeneous, complex systems. According to the results of the systems analysis of impact factors on the efficiency of environmental protection processes, it is suggested to optimize the cleaning equipment due to classified and structural parameters, which would allow design the systematic approaches to the selection of environmental protection equipment in future. The process intensity is considered as an environmental protection process optimization criterion.
Authors and Affiliations
L. L. Hurets, I. S. Kozii, H. M. Miakaieva
Keywords
Related Articles
- EP ID EP248288
- DOI 10.21272/jes.2017.4(2).g12
- Views 89
- Downloads 0
Compression Ignition Engine Performance as a Function of the Fuel Properties
Compression ignition engines have wide application in the transportation, agricultural, construction and industrial sectors which are critical for the economic sustainability of any nation. These engines are powered with...
Influence of an Inlet Rotating Axial Device on the Cavitation Processes in a Low Specific Speed Centrifugal Pump
The paper is devoted to the analysis of the cavitation processes in the flow section of the low specific speed centrifugal pump. A new conception of double-entry hermetic pump leads to the application of special shaped i...
Modelling of the vertical migration process of phosphogypsum components in the soil profile
This paper focuses on the study of the process of vertical migration of phosphogypsum components according to the soil profile. The qualitative and quantitative identification of main biogenic elements (phosphorus, sulph...
Cleaning and disposal of gas emissions from the production of calcinated soda ash
The article is devoted to the issues of reducing the negative impact on the environment of the production of soda ash, which is achieved by reducing the formation of gas and dust emissions, as well as their deeper cleani...
The decrease in technogenic load on the environment during the process of absorption of ammonia in soda industry
The article studies the effectiveness of implementation of existing equipment of soda production absorbers for ammonia cleaning from gas emissions. It identifies the major sources of ammonia emissions in the soda ash pro...