Effect of Different Irrigation Solutions on the Colour Stability of Three Calcium Silicate-Based Materials
Journal Title: Journal of Dental Biomaterials - Year 2017, Vol 4, Issue 2
Abstract
Statement of Problem: Previous studies have shown discoloration of mineral trioxide aggregate (MTA) in contact with root canal irrigation solutions. However, there are limited data on colour stability of other calcium silicate–based materials (CSMs). Objectives: This in vitro study aimed to evaluate the colour stability of three CSMs in contact with different irrigation solutions. Materials and Methods: Three CSMs including White MTA (wMTA) Angelus, calcium enriched mixture (CEM), and Biodentine were assessed in this study. Forty five samples of each material were mixed according to the manufactures’ instructions and then placed in silicone tubes. After 24 hours, the materials were removed from the moulds and 9 samples of each material left dry or immersed in normal saline, 5% sodium hypochlorite (NaOCL), 2% chlorhexidinegluconate (CHX), or 17%EDTA for 24 hours. Colour changes were measured with a spectrophotometer. Data were evaluated with 2-way analysis of variance, one way analysis of variance and Tukey post hoc tests. Results: The highest discoloration of all materials was observed after contact with CHX. In the MTA Angelus and CEM cement groups, significant differences were observed between CHX and NaOCl and also between these two irrigants with the other three irrigants (p < 0.05). In the Biodentine group, CHX created statistically significant discoloration compared to other irrigants (p < 0.05). Only wMTA Angelus showed a significantly higher discoloration in contact with EDTA compared to normal saline and dry condition (p < 0.05). wMTA Angelus showed a significantly higher colour change compared with CEM cement and Biodentine after contact with NaOCl, CHX, and EDTA (p < 0.05). Conclusions: The contact of wMTA, CEM cement, and Biodentine with CHX should be avoided because this leads to severe discoloration. Contact with sodium hypochlorite also leads to discoloration of wMTA and CEM cements. Among of the three tested materials, wMTA showed the highest discoloration after contact with NaOCl, CHX, and EDTA.
Authors and Affiliations
F Sobhnamayan, A Adl, S Ghanbaran
Keywords
Related Articles
- EP ID EP233537
- DOI -
- Views 106
- Downloads 0
Wear Resistance of Acrylic Resin Teeth against Porcelain and Natural Teeth
Statement of Problem: The effect of porcelain surface on the antagonist acrylic teeth has not been widely studied. Objectives: This study aimed to investigate the effect of polished porcelain, glazed porcelain, and natur...
Dimensional Stability of Color-Changing Irreversible Hydrocolloids after Disinfection
Statement of Problem: Disinfection of dental impressions is a weak point in the dental hygiene chain. In addition, dental office personnel and dental technicians are endangered by cross-contamination. Objectives: This st...
Changes in the Concentration of Ions in Saliva and Dental Plaque after Application of CPP-ACP with and without Fluoride among 6-9 Year Old Children
Statement of Problem: The casein phospho peptide-amorphous calcium phosphate with or without fluoride (CPP-ACPF and CPP-ACP respectively) are of considerably new materials which are highly recommended for prevention of d...
Development of a Method to Obtain More Accurate General and Oral Health Related Information Retrospectively
Statement of Problem: Early childhood is a crucial period of life as it affects one’s future health. However, precise data on adverse events during this period is usually hard to access or collect, especially in developi...
The Effect of Time Intervals on Heat Transfer to the Implant-Bone Interface during Preparation of a Titanium Abutment: An in Vitro Study
Statement of Problem: Thermal injury during dental implant placement and restoration is a clinical concern as it may cause bone damage and compromise osseointegration. The threshold level for heat-induced cortical bone n...