Effect of the edge geometry in a cutting chain on the chain saw vibration level
Journal Title: Acta Scientiarum Polonorum Silvarum Colendarum Ratio et Industria Lignaria - Year 2010, Vol 9, Issue 1
Abstract
Vibration levels were measured while cross-cutting pine wood logs. In the experiment five chisel type cutting chains, with a 0.325” pitch were used. The chains differed in the top-plate filing angle which had the following values: 20º, 25º, 30º, 35º and 40º. The cross-cutting was performed by a chain saw operator. The measurements were carried out on the front and rear handles in the x, y and z axes. There were 18 measurements for each top-plate filing angle on each of the handles. The Robotron M1300 meter was used. Considerably higher vibration levels were observed on the rear handle. The effect of the top-plate filing angle on the mechanical vibrations was statistically significant. The correlation between the angle and the vibration value showed a weak relation, but it was statistically significant in those cases in which it appeared.
Authors and Affiliations
Włodzimierz Stempski, Jarosław Wegner, Krzysztof Jabłoński
Keywords
Related Articles
- EP ID EP168502
- DOI -
- Views 49
- Downloads 0
Carpathian beech species composition of the Bieszczady National Park in the period from 1993 to 2003
The paper presents results of the research carried out in beech stands of the Carpathian beech fertile complex (Dentario glandulosae-Fagetum) in the lower subalpine zone in the Bieszczady National Park. The objective of...
First records of Mediterranean cypress bark beetle Phloeosinus aubei (Perris, 1855) (Coleoptera, Scolytinae) from Poland.
It is the first full information about the occurrence of the Mediterranean cypress bark beetle Phloeosinus aubei (Perris, 1855) in Poland. The first observation was made in 2014 near Wrocław and then in 2017 in Poznań. I...
Relations between top-plate filing angle values of cutting chains and chain saw vibration levels
The investigations were conducted on 21 BP Oregon cutting chains, with five top-plate filing angle values: 20°, 25°, 30°, 35° and 40°. The chain saw was a 254 Husqvarna model with an Oregon 15” bar. The vibration measure...
ROŚLINNOŚĆ NOWO UTWORZONYCH UŻYTKÓW EKOLOGICZNYCH „BOGDANKA I” I „BOGDANKA II” W POZNANIU
Praca prezentuje wyniki badań nad roślinnością użytków ekologicznych „Bogdanka I” i „Bogdanka II” zlokalizowanych w północno-zachodniej części Poznania. Podczas badań prowadzonych w czasie sezonów wegetacyjnych 2012 i 20...
Jednorodność serii czasowych temperatury powietrza i opadu atmosferycznego w Wielkopolskim Parku Narodowym.
Celem pracy była ocena jednorodności serii czasowych temperatury powietrza i opadu atmosferycznego, występujących na terenie Wielkopolskiego Parku Narodowego w latach 1848–2017. Park jest położony w środkowej części dorz...