Efficient Control of Doubly Fed Induction Generator Wind Turbine Implementation in Matlab Simulink
Journal Title: International Journal of engineering Research and Applications - Year 2018, Vol 8, Issue 7
Abstract
This paper presents an efficient control of Doubly Fed Induction Generator in variable speed wind power generation. The DFIGs are widely used in variable speed wind energy conversion system (WECS) because their voltage source converters only handle a fraction of the total output power under steady-state conditions. A backto-back power electronic converter (AC-DC-AC) is used in the rotor circuit of the DFIG, allowing the generator to work in both sub-synchronous and super-synchronous mode. In this work the control and implementation of the rotor, grid side and pitch angle controller is detailed. The aim of the grid side converter is to keep the dc-link voltage constant and also compensate the reactive power rather than providing an additional compensating device such as SVC or capacitors banks in parallel to the machine which leads to many problems such as over voltage. The rotor-side converter controls the rotor speed and allows decoupled control between the active reactive powers by using vector control technique. The pitch angle and rotor side controller will be control in coordination to prevent system failure during wind gust. The performance of the control system is demonstrate using Matlab Simulink.
Authors and Affiliations
Ibrahima Ngom, Alioune B Mboup, Abdoulaye Dieng, Nogaye Diaw
Keywords
Related Articles
- EP ID EP394482
- DOI 10.9790/9622-0807010612.
- Views 131
- Downloads 0
Role of Vranadhoopan in The Managementof Chronic NonHealing Ulcers Under The Influence of Tab GandhakRasayan
The Vrana (Ulcer) is a universal problem in India, particularly in rural areas where there is very big problem of traumatic wounds due to the lababorious job in agriculture fields. The wounds become infected due to unhyg...
Heat Transfer and Storage of Sodium Nitrate with Alumina Nanoparticles - Numerical Analysis.
New nanomaterials based on sodium nitrate and different concentrations (0.5%, 1% and 1.5% wt.) of alumina nanoparticles have been analyzed successfully via CFD. A numerical study on differences of thermo-physical propert...
Mining Equipment Analysis to Reach Target Production on Overburden in Kutai Kertanegara East Borneo
Mining equipment operations is one of the vital means to support target production determined. Early activities of mining is clearing land plants (overburden). Data have been obtained and analyzed based on literature rel...
CDR Assessment with Superpixel Segmentation an Effort towards Automatic Glaucoma Detection
Objective: Glaucoma is a chronic eye defect that causes parmanent loss of vision.it is second major cause behind blindness.in this desease optic nerve slowly gets damaged .In early stages of glaucoma patient has no sympt...
A study of Heavy Metal Pollution in Groundwater of Malwa Region of Punjab, India: Current Status, Pollution and its Potential Health Risk
Among the different types of pollution, heavy metal pollution has become one of the major environmental issues in India. A number of studies show that high level of heavy metal exposure is a frequent cause of permanent i...