EFFICIENT CONVERSION OF ENERGY IN THE CONDITIONS OF TRIGENERATION OF HEAT, COOLING AND ELECTRIC POWER
Journal Title: Informatyka Automatyka Pomiary w Gospodarce i Ochronie Środowiska - Year 2015, Vol 5, Issue 4
Abstract
The paper presents the efficiency comparison of the trigeneration system with respect to the separate generation of heat, cooling and electricity. Trigeneration Primary Energy Saving (TPES) indicator was adopted as an assessment criterion. The results of calculations are presented, based on which the analysis of the effect of a variable rate of heat used for cooling, as well as the turbine inlet temperature, on trigeneration system operations have been performed.
Authors and Affiliations
Nadzeya Viktarovich
Keywords
Related Articles
- EP ID EP81542
- DOI -
- Views 106
- Downloads 0
ANALIZA ROZKŁADU POLA ELEKTRYCZNEGO W SEPARATORZE BĘBNOWYM O RÓŻNEJ KONFIGURACJI ELEKTROD
Statyczne pole elektryczne jest wykorzystywane w wielu procesach technologicznych m. in. w procesie separacji elektrostatycznej. Jednym z urządzeń wykorzystującym różne właściwości elektryczne separowanych cząstecze...
TRACTION RECTIFIER-INVERTER SUBSTATION CONCEPT FOR 3 KV DC RAILWAY TRACTION SYSTEM
In recent years, all newly manufactured and put into operation electric rail vehicles are equipped with asynchronous motors and have the opportunity to return the energy to the overhead conytact line system during regene...
DIAGNOSTYKA DOKŁADNOŚCI WSKAZAŃ MULTIMETRÓW CYFROWYCH
Opisano sposoby obliczania błędu maksymalnego dopuszczalnego (BMD) oraz jego dwóch składowych: multiplikatywnej (BDmul) i addytywnej(BDadd). Wyjaśniono zasady diagnostyki dokładności wskazań multimetrów. Zaproponowa...
COMPARISION OF SELECTED FLAME AREA DETECTION METHODS IN VISION DIAGNOSTIC SYSTEM
This paper presents comparison edge detection method of combustion pulverized coal. Compared method are: Canny edge detection operator, level set method and Chan-Vese active contour method. Experimental results show that...
CREATING ALGORITHM FOR SIMULATION OF FORMING FLAT WORKPIECES
Problems of creating of the algorithm and software for the simulation of some metal forming processes are considered. The results obtained in the simulation of the flow pattern of metal for processes of forging and stamp...