Eign-Limits Uncertainty Methodology for Temperature Calibration by Fixed Points and Comparison
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
Calibration measurement uncertainty of Platinum Resistance Thermometer (PRT) was estimated in International Temperature Scale 1990 (ITS-90) at defined fixed points [1]but it was not gives a criteria to find the uncertainty at un-calibrated point within sub ranges between fixed points experimentally, the uncertainty was estimated mathematically. This paper explains the estimation of measuring uncertainty for PRT based on mathematical module able to detect the uncertainty at specified un-calibrated temperature (Intra limits propagation) and the expectation for the Eign-limits using modified supplementary ITS-90equation, this equation was used by modification the factor of sensitivity according to each uncertainty source. It was covered the range from 0°C to 420°C. (Water Triple Point (WTP) 0.01 oC, Gallium Melting Point (GMP) 29.76 °C, Tin Freezing Point (SnFP) 231.9 °C and Zinc Freezing Point (ZnFP) 419.5 °C). Same range was covered in the calibration by comparison method. From this study, a validation for the equation has carried out, the uncertainties in the sub ranges were found to be less than 0.2 mK difference between the real measurements and statistically expectation.
Authors and Affiliations
A. El Matarawy, Doaa Mohamed, Essam Mahmoud
Keywords
Related Articles
- EP ID EP655686
- DOI 10.24247/ijmperdaug201942
- Views 100
- Downloads 0
COMPARISON OF ABLATION RESISTANCE AND THERMAL CONDUCTIVITY OF C-PH AND CNT COMPOSITE LAMINATES
Supersonic aerospace vehicles which operate at very high speeds are supposed to sustain lots of heat due to skin friction. There is always a need for materials which are light in weight and show excellent thermal resista...
Tip Leakage Effects on Flow Field of a Centrifugal Compressor
Tip leakage effects on the flow field of a low speed centrifugal compressor is observed computationally using structured multi block grid with fine grid in the tip leakage region. The computational study of centrifugal c...
Increasing the Productivity by using Work Study in a Manufacturing Industry - Literature Review
Productivity increase by means of a work study in a manufacturing industry is the area of interest in this project. The project was conducted life live, where in numerous types of tools and techniques were employed to im...
Optimization of Elastomeric Passive Engine Mount Using Direct Optimization Method
An ideal engine mount should be able to completely isolate the engine vibration which is caused due to the engine Noise, Vibration and Harshness characteristics. Vibration in an automobile is due to different parts of th...
Synthesis Characterization and Mechanical Behavior of Rice Husk Ash Reinforced Al-20mg 10 Cu Alloy Matrix Hybrid Composites
The aim of this work is to fabricate hybrid composites by using Rice husk ash (RHA), an agro waste as reinforcement to AL-20MG-10CU high strength alloy. Rice husk ash particles of 3, 6, 9 & 12 % by weight were used, to d...