Electrochemical and Tribological Properties of TiSiCN Coatings in Coolant
Journal Title: Materials Science-Medžiagotyra - Year 2019, Vol 25, Issue 2
Abstract
TiSiCN coatings were prepared using DC and RF magnetron co-sputtering system. The influence of target powers on phase structures, mechanical properties, tribological and electrochemical properties were studied. The results indicated the coatings presented an amorphous structure, and the highest microhardness of 1566.4 HV was obtained at a target power of 200 W. In terms of the electrochemical properties in coolant, the higher charge transfer resistance of 2.64 × 107 Ωcm2 and the polarization resistance (~1.10 × 108 kΩ.cm2) were obtained at low target power, indicating a better corrosion resistance. Furthermore, the friction coefficient was 1.01 ~ 1.14 as sliding against SUS440C balls in air. In contrast, the friction coefficient decreased to 0.45 ~ 0.58 in coolant, and the wear mechanism changed from oxidation wear into abrasive wear.
Authors and Affiliations
Zhiwei WU, Shang LI, Fei ZHOU
Keywords
Related Articles
- EP ID EP581465
- DOI 10.5755/j01.ms.25.2.19252
- Views 39
- Downloads 0
Preparation of Foamed Phosphogypsum Lightweight Materials by Incorporating Cementitious Additives
As a byproduct of phosphoric acid industry, phosphogypsum has many environmental problems. In order to recycle phosphogypsum to manufacture lightweight building materials, cementitious additives including fly ash, ground...
Mössbauer Spectroscopy and Magnetic Properties of Bi0.8Ca0.2-xSrxFeO3 Nanoparticles by Sol-gel Method
Doping at A/B-sites can effectively improve the physical properties of perovskite ferrites. In this study, the performance of Bi0.8Ca0.2-xSrxFeO3 was investigated using the sol-gel autocombustion method. The results show...
Tribological Behavior of Cermet Coatings Deposited from Submicron WC-10Co-4Cr Powders Using HVOF Spraying
In this paper, we prepared cermet coatings deposited from submicron WC-CoCr powders using high-velocity oxygen-fuel (HVOF) spraying process. The detailed microstructures, slurry erosion and sliding wear resistance of as-...
Effect of Annealing Temperature on Structural, Morphological, Optical and Electrical Properties of Spray Deposited V2O5 Thin Films
Nanostructured vanadium pentoxide (V2O5) thin films have been deposited by a simple and cost-effective spray pyrolysis technique (SPT) at substrate temperature 300 °C and post annealed at atmospheric conditions in the te...
Influence of Graphene Sheet on Microstructure and Properties of Ni-based Alloy Coatings Prepared by Laser Cladding
Ni-based alloy cladding layers with different graphene sheet additions were prepared by laser cladding on the 40CrNi2Si2MoV steel substrate. The influence of the graphene sheet on the microstructure and properties of the...