Electrochemical Properties of Polyaniline in Aqueous Environments of Iodide and Bromide in the System of Electrochemical Energy Source
Journal Title: Фізика і хімія твердого тіла - Year 2016, Vol 17, Issue 2
Abstract
The influence on specific discharge characteristics of redox - active iodide and bromide electrolytes of polyaniline as the cathode material in electrochemical energy sources with zinc anode was studied. Electrochemical and capacitive properties of PAN cathode was investigated using galvanostatic, potentiostatic, cyclic voltampermetric and impedance methods. It was established that PAN cathode inherent discharge specific capacity of Ср = 126 A × h × kg-1 with current load і = 103 A × kg-1 in zinc - sulfate electrolyte and Ср = 301 A × h × kg-1 in the same conditions in the presence of KI. Thus there is a reverse transition of various forms of PAN leucoemeraldine / emeraldine, that among the redox electrolyte causes increase in electrical capacitance and conductivity of PAN electrodes in the charged state.
Authors and Affiliations
B. P. Bakhmatyuk, O. I. Аksimentyeva, I. Ya. Dupliak, Yu. Yu. Horbenko
Keywords
Related Articles
- EP ID EP255177
- DOI 10.15330/pcss.17.2.234-240
- Views 36
- Downloads 0
Microstructure and Properties of AlCrCoNiCuFeх (х =0 – 2.0) High-Entropy Alloys
AlCrCoNiCuFeх (x values in molar ratio, x = 0; 0,5; 1,0; 2) high-entropy alloys were prepared using a vacuum arc melting method. The effects of Fe addition on microstructure and mechanical properties were investigated. T...
Engineering of Point Defects and Formation Mechanisms of PbTe–CdTe Solid Solutions
The crystal-quasichemical formulas were proposed in paper. There were obtain the dominant point defects of Pb<sub>1-x</sub>Cd<sub>x</sub>Те solid solutions on the base of initial binary solutions PbТе and CdTe of the n-...
Influence of Plasticizers on the Stress State of Epoxy Composites
The results of researches of influence of plasticizers and fillers on the stress state of epoxy composites during solidification and thermal shocks have been shown. It has been observed the influence of plasticizers base...
Structure, Energy State and Electrokinetic Characteristics of Zr1+xCo1-xSb Solid Solution
The features of the crystal and electronic structures, electrokinetic and energy state characteristics of Zr1+xCo1-xSb semiconductor solid solution in the temperature range T = 80 ÷ 400 K were investigated. The mechanism...
The Defects Modeling in ZnSe Crystals with Isovalent Mg Impurity
The calculation of equilibrium defects concentration in ZnSe crystals, doped with Mg isovalent impurity, is performed by quasichemistry reaction method. It is shown, that single charged vacancies of zinc, selenium and in...