Enhancing Power Quality in Transmission System Using Fc-Tcr
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2014, Vol 4, Issue 3
Abstract
FACTS methodology is totally based on power electronics devices which are used to increase the transmission capability. To make the power system flexible, FACTS technology is used to attain entire control of power system i.e. transmission, distribution and generation. This paper is mainly concerned about the significance of Fixed Capacitor Thyristor Control Reactor (FC-TCR) acquiring automatic power and steady state voltage stability with the help of fuzzy logic controller. In transmission systems, the fuzzy rules are set to generate the required firing angle of FC-TCR to maintain a flat profile of steady state voltage and stability. The fundamental model is simulated in MATLAB along with the fuzzy logic control strategy. The results obtained are trust worthy and it can be used for controlling the voltage and reactive power in any electrical transmission system.
Authors and Affiliations
Abhishek Kumar Pashine1 , Satyadharma Bharti
Keywords
Related Articles
- EP ID EP131519
- DOI -
- Views 112
- Downloads 0
Continuum Modeling Techniques to Determine Mechanical Properties of Nanocomposites
Nanotechnology offers fundamentally new capabilities to architect a broad array of novel materials, composites and structures on a molecular scale. A review of modeling techniques for predicting the mechanical behavior o...
Trajectory Control With MPC For A Robot Manipülatör Using ANN Model
In this study, in a computer the dynamic motion modelling of manipulator and control of trajectory with an algorithm this has been tested. First after dynamic motion simulation of manipulator has been made MPC Cont...
Lossy Transmission Lines Terminated by Parallel Connected RC-Loads and in Series Connected L-Load (I)
Abstract: The present paper is the first part of investigations devoted to analysis of lossy transmission lines terminated by nonlinear parallel connected GC loads and in series connected L-load (cf. Fig. 1). First...
Optimal Location and Sizing of DG using Fuzzy logic
Introduction of distributed generation modifies the structure of power system network. High levels of penetration of distributed generation (DG) are new challenges for traditional electric power systems. A powe...
Analysis of Non Conventional Cross Section of Pipe Made Of Composite Material
In this study, non-conventional cross-sectioned composite pipes [i.e. rectangular and triangular cross-sections] have been proposed, fabricated, tested and analyzed because of their ability to be bundled withou...