Evaluation of the permissible moment in a roller cone drill bit providing the prescribed reliability of work
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2018, Vol 4, Issue 1
Abstract
After analyzing the nature of the damage of surfaces was discovered the traces of the compression effect which arise along the cutters axis when squeezing it into the rock of delve. There were also founded the traces of deformation from the action of bending to the cutter, depending on the orientation of its slip on the face. We noticed the rubbing, fretting-corrosion, damage the local areas of the apertures walls caused by scrolling the cutter around its axis in the aperture of cones crown. In the case of the use of cutters with symmetrical aggravation of the rock-destructive part, the orientation of the generating line of active part of the cutter is determined by an effective angle to the axis of the crown of the cone. Calculations show that an angle of 45° is optimal. We noticed the rubbing, fretting-corrosion, damage the local areas of the apertures walls caused by scrolling the cutter around its axis in the aperture of cones crown. The analysis of types of rock-destructive equipment of cones damages has been revealed that with increasing the magnitude of the axial load on the bit, cases of splitting, destruction of hard-alloyed cutters increase. For this purpose, it is necessary to protect the drill`s crowns from cementation. If carbide cutters are located in several rows in the cone drill, then milling of the sites on cemented layer`s depth is effective. This prevents the removal of parts of cone`s crown. The allowable moment is proportional to the square of the height, so the connections which perceive the considerable bending moments cannot be performed with small values of the diameter or small height of the cutter shank.
Authors and Affiliations
Andriy Slipchuk
Keywords
Related Articles
- EP ID EP498221
- DOI 10.23939/ujmems2018.01.116
- Views 108
- Downloads 0
Optimization of Conditions of Electroslag Welding of Bandings of Rotary Units
The design of banding shells of rotary units is analyzed. It is shown that combined welding and cast manufacturing of bandings is used in the case of large structural sizes. The basic materials (30, 35, 25 HSL and 30 HML...
The Influence of Chemical-Thermal Treatment on Granulometric Characteristics of Titanium Sponge Powder
The phase composition and structure of powders of titanium sponge exposed to processes of chemical and thermal processing is investigated. As a result of X-ray analysis, it is found that after hydrogenation titanium powd...
Nonlinear Analysis in Synthesis of the Resonant Vibro-Impact Systems
The paper considers differential equation of the vibro-impact resonance system with an asymmetric piecewise linear elastic characteristic. The time-instant of switching of elastic characteristic is determined on the basi...
The Hydro-Automatic Damping System against Dynamic Vibrations
A review and analysis of the developed hydraulic system for quenching dynamic oscillations has been carried out. A mathematical model for determining the operation delay time of the hydraulic system of the dynamic quench...
Research of Influence of Oscillations of Tool-Part System on Roughness of Surface Layer during High-Speed Friction Strengthening
During the discontinued friction strengthening except of the high-speed friction the processes of high-frequency shock loadings appears in the tool-part contact zone. The vibrations occur in the machine elastic system. D...