Evaporation Rate of Water from Glass Surface Under Natural and Forced Convection
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
This article discusses the question of calculating of evaporation rate of water from glass surface at the final stages upon natural and forced convection at atmosphere pressure in isothermal conditions. Petri dish was used as glass surface. At the end of evaporation of single-component liquid (water) position of experimental points in the liquid weight–evaporation time plot deviates from linear dependence. This deviation characterizes gradual decrease in amount of evaporated moisture per equal time intervals and does not imply decrease in evaporation rate. The evaporation rate corresponds to the rate of mass transfer expressed in kg/(m2·s). Water placed into Petri dish is referred to wetting moisture (free moisture), its evaporation rate equals to evaporation rate of water from free surface. Initial evaporation surface is the same as the surface of the water mirror placed into Petri dish. During evaporation water does occupy not the entire surface of the bottom of the Petri dish, but only a certain part of it, wherein evaporation surface (mass transfer surface) is the surface of water bordering on the air. Article accepted that relative variation of mass transfer surface area is proportional to relative variation of moisture weight with certain coefficient of proportionality. The proposed dependence in the first approximation is accepted to be linear. Calculated decrease in water weight in time with consideration for the introduced adjustment agrees with experimental data obtained under natural and forced convection. Evaporation rate increases during water heating and remains constant during overall evaporation process.
Authors and Affiliations
Tatyana Germanovna Korotkova, Aleksandra Sergeevna Danilchenko, Yuriy Nikolaevich Sedoy
Keywords
Related Articles
- EP ID EP656720
- DOI 10.24247/ijmperdaug201997
- Views 92
- Downloads 0
INVESTIGATION OF TOOL LIFE IN AL / SIC COMPOSITE MATERIAL WITH ULTRASONIC WAVES MACHINING
The machining process is one of the most widely used methods in manufacturing metal parts. The most important issues of machining are the life of the tool. The life of the tool ,in turn, is influenced by the regulatory p...
Evaluating the Performance and Emission Characteristics of CI Engine with Waste Plastic Oil
The continuous increase of demand for energy, diminution of oil recourses and stringent pollution norms encourage the researchers to find alternate fuels. Waste converted to fuel, a technique to get alternate fuels is an...
Design and Analysis of An Integrated Exhaust Manifold with Turbocharger for Considerable Reduction of Over Heating of Bearing System
Presently in turbocharger, turbine housing and exhaust manifold are supplied as two separate components to the engine manufacturer. It was observed that the flow path in the exhaust manifold was improper and led to high...
Effect of Crumb Rubber Aggregates on the Characteristics of Cement Concrete as Partial Replacement
Concrete is an outstanding structural substantial, and is regarded as beneficial for the modern civilization as well as human society. Henceforth, the manipulation of crumb rubber in concrete has been considered technica...
DMATM: Dual Modified Adaptive Technique Based Multiplier
The most critical arithmetic functional units are digital multipliers. This system overall performance is depends on the throughput, of the multiplier. An n-bit by n-bit multiplier can be employed by an n-bit by n-bit mu...