Experimental Evaluation of Mechanical Properties of Friction Welded Dissimilar Steels under Varying Axial Pressures
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2016, Vol 66, Issue 1
Abstract
The present study emphasizes on joints two industrially important materials AISI 304 with AISI 1021steels, produced by friction welding have been investigated. Samples were welded under different axial pressures ranging from 75MPa to 135MPa, at constant speed of 920rpm. The tensile strength, torsional strength, impact strength and micro hardness values of the weldments were determined and evaluated. Simultaneously the fractrography of the tensile tested specimens were carried out, so as to understand the failure analysis. It was observed that improved mechanical properties were noticed at higher axial pressures. Ductile failures of weldments were also observed at 120MPa and 135MPa axial pressures during fractography analysis.
Authors and Affiliations
Amit Handa and Vikas Chawla
Keywords
Related Articles
- EP ID EP43880
- DOI https://doi.org/10.1515/scjme-2016-0008
- Views 296
- Downloads 0
Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil
The biodiesel has lower volatility and is costlier than the fossil diesel. Hence it is necessary to add a low cost fuel which has higher volatility, with the diesel. The tire pyrolysis oil (TPO) produced from waste tire...
Study on Breaking Load of Single Lap Joint Using Hybrid Joining Techniques for Alloy Steel AISI 4140 and Mild Steel: Taguchi and Neural Network Approach
The present investigation carried out to analyze the breaking load of single lap joint using hybrid joining techniques for alloy steel AISI 4140 and mild steel as base material by experimentally and optimized by Taguch...
Vehicle Speed Determination in Case of Road Accident by Software Method and Comparing of Results with the Mathematical Model
The paper addresses the problem to vehicle speed calculation at road accidents. To determine the speed are used the PC Crash software and Virtual Crash. With both methods are analysed concrete cases of road accidents....
Optimization of Sluice Gate under Fatigue Life Subjected for Forced Vibration by Fluid Flow
A ‘Sluice’ is a water-flow control gate works with sliding. So, it’s a mill race, flume or a penstock, channelling water towards a water mill, traditionally a wood or metal barrier sliding in grooves that are set in the...
Analysis of the Effect of the Addendum Modification Coefficient for Contact Surfaces of Spur Gear
The spur gear is widely used in many types of machines and appliances that is why the research of the connection analysis of them (Tooth Contact Analysis, TCA) is very important because of the development of these gear...