EXPERIMENTAL SUBSTANTIATION OF THE CALCULATION PROCEDURE OF NORMALIZED PARAMETERS OF GROUNDING DEVICE BASED ON THE THREE-LAYER SOIL MODEL
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 1
Abstract
Purpose. Experimental substantiation of the possibility of using the calculation procedure of normalized parameters grounding devices on the basis of a three-layer model soil. Methodology. The research was based on comparison of the results of experimental measurements for the existing high voltage energy facilities of Ukraine with the results of the calculation. Results. Comparison showed that the average error decreased from 18 % for the two-layer model to 10 % for the three-layer model. The analysis of the calculated and experimentally determined values of the touch voltage showed a high degree of coincidence. Originality. The adequacy of the calculation procedure of the normalized parameters of the grounding device for model with three-layer soil is substantiated by the results of experimental research on the existing energy objects. Practical value. The obtained results allow us to use calculation procedure to create software to determine with increased accuracy the normalized parameters of grounding device located in three-layer soils.
Authors and Affiliations
D. G. Koliushko, S. S. Rudenko
Keywords
Related Articles
- EP ID EP485188
- DOI 10.20998/2074-272X.2018.1.11
- Views 105
- Downloads 0
V.G. Dan'ko
In the article the fault current limiter of inductive type with high-temperature superconducting coil and screen is considered. Main features of transient at occurrence of short circuit are analyzed.
MODELING PARAMETERS OF ARC OF ELECTRIC ARC FURNACE
Purpose. The aim is to build a mathematical model of the electric arc of arc furnace (EAF). The model should clearly show the relationship between the main parameters of the arc. These parameters determine the properties...
IDENTIFICATION OF TEMPERATURE DEPENDENCES OF CENTER-PUNCH SPECIFIC ELECTRICAL RESISTANCE DURING GRAPHITIZATION
A temperature dependence identification technique is worked out for graphitization furnace center-punch specific electrical resistance through applying a special object-oriented functional basis and temperature dependenc...
MODELING OF OPERATION MODES OF SHIP POWER PLANT OF COMBINED PROPULSION COMPLEX WITH CONTROL SYSTEM BASED ON ELECTRONIC CONTROLLERS
Purpose. Designing of diagrams to optimize mathematic model of the ship power plant (SPP) combined propulsion complexes (CPC) for decreasing operational loss and increasing fuel efficiency with simultaneous load limiting...
ELECTROMECHANICAL PROCESSES IN A LINEAR PULSE-INDUCTION ELECTROMECHANICAL CONVERTER WITH A MOVABLE INDUCTOR AND TWO ARMATURES
Purpose. The purpose of the paper is to determine the influence of the height of the mobile and stationary disk electrically conductive armatures covering the movable inductor on the electromechanical processes of linear...