FACTORS INFLUENCING AXIAL COMPRESSOR STALLS
Journal Title: Scientific Journals of Silesian University of Technology. Series Transport - Year 2017, Vol 95, Issue 95
Abstract
The article describes the problem regarding stalls in axial compressors, which are widely used in the engines of large and very large transportation aircrafts. The stall phenomenon, unless cleared, poses a major danger to the integrity of a compressor module, which in turn may result in uncontained engine failure and loss of thrust, thereby seriously affecting flight safety. The costs of maintenance to be performed may also be very high, due to irreversible deterioration in some components. A practical assessment of the stall problem and its countermeasures are discussed below.
Authors and Affiliations
Piotr LASKOWSKI
Keywords
Related Articles
- EP ID EP329272
- DOI 10.20858/sjsutst.2017.95.9
- Views 39
- Downloads 0
A “JUST CULTURE”? CONFLICTS OF INTEREST IN THE INVESTIGATION OF AVIATION ACCIDENTS
The sole purpose of air accident investigations should be the prevention of accidents and other incidents in the future, without apportioning blame or liability. A civil aviation safety system is based on feedback and le...
INCHES FROM A PLANE CRASH: TERMINOLOGY, CAUSES, INVESTIGATIVE ACTIVITIES AND RESPONSIBILITY
The author of this article will discuss issues related to aircraft accidents. The paper will set out the investigative activities carried out by Poland’s State Commission on Aircraft Accidents Investigation. The author w...
WYKORZYSTANIE METOD WIBROAKUSTYCZNYCH W DIAGNOSTYCE SILNIKÓW SPALINOWYCH
Drgania i hałas silnika spalinowego są nośnikiem informacji o stanie jego podzespołów mechanicznych. Energia sygnału drganiowego, generowanego w układzie tłokowo-korbowym, zależy od średniej prędkości obrotowej oraz poło...
USE OF FEM FOR MARKING INFLUENCE OF CRACKING GEAR-TOOTH ON CHANGES STIFFNESS OF MESHING
The work presents results of researches aimed at calculation influence of cracking on changes of meshing stiffness of gear-tooth. The researches was done by used FEM.
PROBLEMS OF IC ENGINES MECHANICAL FAULT DIAGNOSTICS
The main purpose of modern, on board, diagnostic systems supervising electronic control systems is to check whether the ecological requirements are met. It means that the OBD system monitors catalyst and ignition system...