FEM Analysis of Connecting Rod of different materials using ANSYS
Journal Title: International Journal of Engineering and Techniques - Year 2015, Vol 1, Issue 3
Abstract
Connecting Rods are practically generally used in all varieties of automobile engines. Acting as an intermediate link between the piston and the crankshaft of an engine. It is responsible for transmission of the up and down motion of the piston to the crankshaft of the engine, by converting the reciprocating motion of the piston to the rotary motion of crankshaft. Thus, this study aims to carry out for the load, strain and stress analysis of the crank end of the connecting rod of different materials. Based on which the High Strength Carbon Fiber connecting rod will be compared with connecting rod made up of Stainless Steel and Aluminum Alloy. The results can be used for optimization for weight reduction and for design modification of the connecting rod. Pro-E software is used for modeling and analyses are carried out in ANSYS software. The results archived can also help us identify the spot or section where chances of failure are high due to stress induced. Also the results obtained can be used to modify the existing designs so that better performance and longer life cycle can be archived.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP354663
- DOI -
- Views 114
- Downloads 0
Pre-processing data using ID3 classifier
A Decision tree is termed as good DT when it has small size and when new data is introduced it can be classified accurately. Pre-processing the input data is one of the good approaches for generating a good DT. When diff...
Landscape Pattern Mining using Machine Learning Intelligence
The complexity of landscape pattern mining is well stated due to its non-linear spatial image formation and inhomogeneity of the satellite images. Land Ex tool of the literature work needs several seconds to answer input...
Performance evaluation of hybrid wind and solar power
A hybrid power system which consists of PV-arrays and wind turbines with energy storing devices (battery bank) and power electronic devices has been discussed in this paper to achieve an efficient and cost competitive sy...
Controller Tuning for Disturbance Rejection Associated with Delayed Double Integrating Processes, Part V: 2DOF Controller
The objective of the paper is to investigate the possibility of using a 2DOF controller in disturbance rejection associated with delayed double integrating processes. The effect of time delay of the process in a range be...
Receiver Initiated Asynchronous Duty-Cycle MAC protocol For Burst Traffic
Many energy-efficient Receiver Initiated Asynchronous Duty-Cycle MAC protocol for wireless sensor networks (WSNs) have been proposed. Most nodes suffer from significant performance Degradation for burst traffic, due to r...