Finite Element Analysis and Experimentation of Carbon Fibre Chain Drive
Journal Title: GRD Journal for Engineering - Year 2017, Vol 2, Issue 12
Abstract
Chain drives are most important systems used in industry to carry the products and to transmit the power. But limitation is the chain drive suffers premature elongation due to wear and so that the costs of production will increases and ultimately the cost of operations also increases. In case of power transmission chain, the major factor affected on failure of chain is tensile load. It will be helpful to reduce the cost and time of production related to chain assembly of above said industries. The power transmission chain is used to transmit the power which deals with different load conditions. This causes wear and tear of components of chains and hence unexpected failure and costly production. In present work the study of different failures of chain links under different loading conditions using Mild Steel will be done. It was determined that maximum amount of weight of chain drive is covered by outer link and inner link. The chain is analyzed using Hyper-mesh and ANSYS software. The static loads are applied on the chain drive and analysis is carried out. The test is carried out to check the conformance of the existing design. The chain drive is optimized by changing it to carbon fiber material. Based on these results, best feasible design solution is proposed and validated experimentally.
Authors and Affiliations
Mrs. Bhagyashri H. Dhage, Prof A. D Diwate
Keywords
Related Articles
- EP ID EP282822
- DOI -
- Views 92
- Downloads 0
CMOS VLSI ARCHITECTURE OF LOW POWER LEVEL SHIFTER
Dual-supply voltage design using a clustered voltage scaling (CVS) scheme is an effective approach to reduce chip power. The optimal CVS design relies on a level converter implemented in a flip-flop to minimize energy, d...
Implementation of Low-level control in Autonomous Ground Vehicle
The goal of this paper is to compute odometry of vehicle using low-level controls combined with inertial measurement unit. The Low-Level control includes design of Drive-by-Wire mechanisms for steering, brake and acceler...
Hardware Implementation of MAC using MATLAB Simulink and FPGA
The MAC unit is considered as one of the fundamental operations in DSP and it becomes a basic component in Application-Specific-Integrated-Circuits (ASIC).The MAC unit determines the speed of the overall system; it alway...
E2RPQ- Enhanced Energy Receiver Priority queuing Algorithm for VoIP (QOS) Over Manet
Energy Efficient in the VoIP broadcast is the main criterion and issue to be maintaining the small package and data as dispensation VoIP (QoS) over Manet environment. Mobile Adhoc network (MANETs) presents a good stage f...
Design of Fuzzy gain scheduled PI Controller for a nonlinear SISO Process
The typical nonlinear process such as conical tank and spherical tank process has the difficulty in controller design because of a change in system dynamics and valve nonlinearity. All industrial processes are almost non...