FINITE ELEMENT BASED PREDICTION OF DEFORMATION IN SHEET METAL FORMING PROCESS
Journal Title: Applied Computer Science - Year 2018, Vol 14, Issue 3
Abstract
In this paper the sheet forming process of cylindrical drawpieces was sim-ulated based on the finite element method by the explicit approach in the pres-ence of contact conditions with isotropic and anisotropic friction. The ex-perimental and numerical results obtained in the Abaqus finite element (FE) based program are presented. The aim of the experimental study is to analyse material behaviour under deformation and in addition to use the results to verify numerical simulation results. It was found that, although, the anisotropy of resistance to friction affects the height of ears, the influence of the friction formulation is relatively small in comparison with material anisotropy. The study indicates that FE analysis with 3-node triangular shell element S3R elements ensures the best approximation of the numerical results to the real process when both material and friction anisotropy are taken into account.
Authors and Affiliations
Damian KRASKA, Tomasz TRZEPIECIŃSKI
Keywords
Related Articles
- EP ID EP559257
- DOI 10.23743/acs-2018-20
- Views 103
- Downloads 0
TESTS OF HTS 2G SUPERCONDUCTING TAPES USING THE LABVIEW ENVIRONMENT
HTS 2G superconducting tapes without stabilizer are used for the construction of superconducting fault current limiters. The characteristics R =f(T) of the su-perconducting tape is essential for design of superconducting...
DETERMINATION OF RELATIVE LENGTHS OF BONE SEGMENTS OF THE DOMESTIC CAT'S LIMBS BASED ON THE DIGITAL IMAGE ANALYSIS
This paper is an introduction to the issues related to obtaining information on the metric dimensions of selected bone segments of a domestic cat based on the analysis of digital images. The main objective is to acquire...
IDENTIFICATION OF A BACKLASH ZONE IN AN ELECTROMECHANICAL SYSTEM CONTAINING CHANGES OF A MASS INERTIA MOMENT BASED ON A WAVELET–NEURAL METHOD
In this article a new method of identification of a backlash zone width in a structure of an electromechanical system has been presented. The results of many simulations in a tested model of a complex electromechanical s...
COMPARATIVE ANALYSIS OF THE IMPACT OF DIE DESIGN ON ITS LOAD AND DISTRIBUTION OF STRESS DURING EXTRUSION
In the paper a numerical comparative analysis of stresses in a steel die com-pressed by a ring during the extrusion process was presented. In the research, three design solutions of the die were used. The solutions vary...
APPLICATION OF ACOUSTIC SIGNAL PROCESSING METHODS IN DETECTING DIFFERENCES BETWEEN OPEN AND CLOSED KINEMATIC CHAIN MOVEMENT FOR THE KNEE JOINT
The paper presents results of preliminary research of analysis of signals recorded for open and closed kinematic chain in one volunteer with chon-dromalacia in both knees. The preliminary research was conducted in order...