Firmware implementation and experimental research of the phase-locked loop with improved noise immunity
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 5, Issue 9
Abstract
<p>This paper presents a method for improvement of the phase-locked loop (PLL) noise immunity by using a modified phase detector. The article shows structural diagram of the PLL with the modified phase detector and describes the criterion for choosing the parameters of the narrowband filter and the high-pass filter to prevent distortions of information signal. Simulation of both classical and modified devices was carried out to find a noise threshold, which causes phase-locked loop to unlock. Simulation results show that multiple cycle slips of synchronization in short period of time in modified PLL occur for higher levels of noise (by 1.5–4 dB depending on PLL parameters), than in classical PLL. Both devices were software implemented on FPGA (field programmable gate array) logic and experimental studies of their noise immunity were conducted. The results of experimental studies qualitatively correspond to simulation ones and show that the that noise threshold of the modified phase detector is greater up to 1–2.5 dB depending on the device parameters. Experimental research also shows that modified phase detector does not deteriorate the dynamic properties of whole device and even improves them in comparison to classical PLL.</p>
Authors and Affiliations
Andrii Bondariev, Serhii Altunin, Ivan Horbatyi
Keywords
Related Articles
- EP ID EP528210
- DOI 10.15587/1729-4061.2018.143178
- Views 71
- Downloads 0
Design of the composition of alkali activated portland cement using mineral additives of technogenic origin
<p>This paper reports results of the development of cement compositions and production technology for common cement systems "portland cement clinker – mineral additives – alkaline activator – water-reducing admixture", w...
The effect of external magnetic flux field in the QTS weldment on the change of fatigue crack propagation behaviors
<p class="a">This investigation discusses fatigue crack propagation behaviors on the welded joint of Hot Rolled Quench Tempered Steel (QTS) in which during welding process the fusion zone of the joint was subjected to ma...
Modeling the elastic impact of a body with a special point at its surface
We have considered the elastic straight impact along a flat border of the stationary half-space of the body bounded in a zone of contact interaction by the surface of rotation, whose order is smaller than two. The featur...
Combination of vegetable-fruit formulation composition for obtaining high quality products
<p>We have investigated a change in the active acidity of blended products made from vegetable and fruit raw materials. A possibility has been proven to control active acidity through the introduction to formulations of...
Improving power efficiency of pneumatic logistic complex actuators through selection of a rational scheme of their control
<p>The work addresses solving important problems that occur when using pneumatic actuators, namely energy saving and expanding the scope of its use by covering the zone of large inertial loads at a constant maintenance o...