Friction and Material Modelling in Finite Element Simulation of Orthogonal Cutting
Journal Title: Tribology in Industry - Year 2015, Vol 37, Issue 4
Abstract
In the present paper the influence of the friction and material modelling on the results of the Finite Element simulations of machining is investigated. An orthogonal cutting model is proposed, which incorporates Coulomb’s friction law. The validity of this model is tested against similar experimental and numerical results from the relevant literature and the influence of the friction coefficient is investigated. Then, a second model, with a friction model based on Zorev’s stick-slip theory, is prepared and compared to the first one. Furthermore, simulations with Johnson-Cook material model for both kinds of friction modelling are presented and compared to the other models. The results of the different kinds of models although exhibit small discrepancies between models’ results such us cutting forces, affect temperatures and chip morphology.
Authors and Affiliations
A. P. Markopoulos , N. M. Vaxevanidis , D. E. Manolakos
Keywords
Related Articles
- EP ID EP164266
- DOI -
- Views 91
- Downloads 0
Thermal and Dry Sliding Wear Behavior of Plasma Sprayed Red Mud-Fly Ash Coatings on Mild Steel
The present work focuses to understand the limitations towards high temperature applications of plasma sprayed coatings like pure red mud, composited with varying weight % (10, 20 and 50) of fly ash on mild steel. Sprayi...
Effects of Viscosity Variation and Surface Roughness on the Couple stress Squeeze Film Characteristics of Short Journal Bearings
The theoretical analysis of the combined effects of surface roughness and viscosity variation on the couple stress squeeze film characteristics of short journal bearings is presented. The modified stochastic Reynold’s eq...
Three Body Abrasive Wear Behavior of Glass-Basalt PA66/PTFE Hybrid Composites in Multi pass Condition
The three body abrasive wear (3-BAW) of Glass – Basalt hybrid composites is studied. The PA66/PTFE blend(80/20 wt.%), Blend/Short glass fiber(SGF), Blend/Short Basalt fiber(SBF),Blend/10 wt.% SGF/10 wt.% SBF (GB) were th...
Effect of Composition on Mechanical Properties of Mullite-WC Nano Composites Prepared by Spark Plasma Sintering
Mullite-WC composites were prepared from Mullite and WC powders by spark plasma sintering at 1400 °C for a holding time of 180 s under 30 MPa. Microstructure, strength, and hardness of the mullite-WC composites were stud...
Different Ways of Friction Coefficient Determination in Stripe Ironing Test
The sheet metal stripe ironing laboratory test has been developed to study tribological appearances and performance of lubricants in ironing process. Most common way for friction coefficient determination in the test is...