Three Body Abrasive Wear Behavior of Glass-Basalt PA66/PTFE Hybrid Composites in Multi pass Condition
Journal Title: Tribology in Industry - Year 2019, Vol 41, Issue 3
Abstract
The three body abrasive wear (3-BAW) of Glass – Basalt hybrid composites is studied. The PA66/PTFE blend(80/20 wt.%), Blend/Short glass fiber(SGF), Blend/Short Basalt fiber(SBF),Blend/10 wt.% SGF/10 wt.% SBF (GB) were the composites selected for the investigation. These composites were fabricated using twin screw extrusion and then subjected to injection molding. The experimentation has been carried out for different load (20 and 30 N) with varying distance through constant velocity (2.5 m/s) as per ASTM G65 method. It is revealed from the experimentation that the fiber filled composites exhibited better abrasion resistance. The hardness of composites, abrasion resistance of fibers and binding energy between the blend associates were found to resist the failure of composites in three body abrasion. Further, the Glass – Basalt composites (GB) exhibits good wear resistance because of their excellent Ratner - Lancaster factor (σε). It is observed that the high crystallanity of GB hybrid composites has supported the abrasion resistance. The hardness ratio between the rubber wheel and the composites is quite greater than unity. On the other hand, plastic deformation, fiber pull out and agglomeration of sand particles along with wear debris were some of the observations made during morphology of hybrid composites through SEM pictures.
Authors and Affiliations
B. M. Rudresh, B. N. Ravikumar, B. V. Lingesh, D. Madhu
Keywords
Related Articles
- EP ID EP644525
- DOI 10.24874/ti.2019.41.03.11
- Views 109
- Downloads 0
Hydrodynamic Lubrication of Textured Journal Bearing Considering Slippage: Two-dimensional CFD Analysis Using Multiphase Cavitation Model
Partial texturing of the surface of journal bearings have been proven very beneficial in terms of friction coefficient. In the present work, the load support of the hydrodynamic textured journal bearing combined with art...
Friction Behavior Produced in The Course of a Contact Enabled Between Composite Materials and Eco-Friendly Soles Prototypes Made of Elastomeric Material with Regard to Ice-Covered Surface
The subject matter of the present research constitutes a study of the technique of friction between samples and prototypes of soles made of composite materials comprising natural rubber characterized with ingredients ori...
Reduction and Maintance of Turbochargers by Applying Valid Tribological Constructing
Condition recordings and turbochargers test results indicate that during the long driving at higher speeds may cause turbochargers overheat. Lubricate termination after shutting generator can cause damage to the sliding...
Fracture Toughness and Tribological Wear Behaviour of Micro Alloyed Pearlitic- Ferritic Ductile Cast Iron
Fracture toughness and wear behaviour of micro alloyed ductile iron were investigated. Hardness, fracture, fracture toughness and wear tests were carried out on the ductile irons samples (D1, D2, D3, D4 and D5), containi...
Tribological Processes of the Mechanisms of Free Motion of Impulsive Friction Variators
Free motion mechanism (FMM) of the impulsive variators is one vital part in power transmiting of impulsive lever variators which oscillating motion of external envelope (coulisse) converted in rotation movement of the ou...